Advertisement
Quick Links
2016-2018 ICON LINK
Valley ICON Panels
Intro 1 – Page 2
– Introduction
Section 1 – Page 3 – Unit Mounting
Section 2 – Pages 4-9 – Unit Wiring
Section 3 – Page 10 – Valley ICON Panel Configuration
Section 4 – Page 11 – ICON LINK Configuration
Section 5 – Page 11 – ICON LINK LED's
Section 6 – Page 12-13 – Specs and Warranty
1
Advertisement
Summary of Contents for Valley ICON LINK
- Page 1 Section 1 – Page 3 – Unit Mounting Section 2 – Pages 4-9 – Unit Wiring Section 3 – Page 10 – Valley ICON Panel Configuration Section 4 – Page 11 – ICON LINK Configuration Section 5 – Page 11 – ICON LINK LED’s...
- Page 2 Introduction The all new 2016 ICON LINK unit mounts inside the control panel door of Valley ICON digital irrigation control panels. The ICON LINK unit communicates directly with the digital control panel to monitor/control the irrigation system remotely via the Wagnet.net website or Wagnet Mobile App.
- Page 3 Turn off the main disconnect on the Valley ICON panel, and open the door fully. Using the three screws and nuts provided in the install kit, mount the ICON LINK to the inside of the Valley control panel door as shown below.
- Page 4 ICON LINK Wiring ICON LINK Serial Cable Connection Connect the included Serial Cable to the ICON LINK “Panel Serial 1” port as shown in the photo below.
- Page 5 Connect the opposite end of the Serial Cable to the Valley panel 9 pin Serial Port (J12) on the SRB Relay board in the panel as shown in the photo below.
- Page 6 2. Then, route the Antenna cable plus the Red, and Red/Black wires next to the existing door cables/wires and through the existing wire holders on the Valley panel door up to the ICON LINK and plug in the wire harness to the ICON LINK as shown in the photo below.
- Page 7 (gold screw connection) 4. Use the included zip-ties to secure the wires neatly to the existing Valley wires as needed. 5. Attach the RED (+12v) and RED/BLACK (GND) wires to the SRB relay board J7 in the Valley panel as shown below.
- Page 8 6. After all wires are attached and secured, make sure the power switch on the ICON LINK is turned on, and then close the Valley panel door and turn the main disconnect switch on. 7. If your ICON Link came with the Theft Monitor as a separate kit, please wire it in as shown above.
- Page 9 Valley ICON Panel Configuration The Valley ICON panel will already be set to the correct configuration from the factory. If needed, you can check the following items in the Valley panel menu to confirm that the following items are set correctly: Constants Menu: 1.
- Page 10 GPS LED – This LED is not used at this time. CHR5V LED – This light is on steady when the Valley panel main disconnect is turned on. SERIAL 1– This LED flashes when the ICON LINK successfully...
- Page 11 Power Requirements for the ICON LINK unit: 12v DC: 1.0A MAX 0.05A - 0.25A during normal operation Warranty Information: All warranty service provided by the AgSense service center, or an authorized technician. Warranty repairs require a Return Merchandise Authorization Number (RMA);...
- Page 12 Customer's equipment, GPS, Satellite or Internet to function properly. CUSTOMER'S RESPONSIBILITIES: Customer agrees to keep the irrigation equipment upon which Field Commander/Crop Link/Aqua Trac/CommanderVP/Icon Link is installed in good repair and maintenance. Customer acknowledges the importance of and agrees to keep all safety devices which came with Customer's irrigation equipment in working order.
Need help?
Do you have a question about the ICON LINK and is the answer not in the manual?
Questions and answers