Assembly Instructions; Unpack The Flat Pack; Assemble The Main Frame; Assemble Disc Gang Assemblies To The Main Frame - Grizzly Field Boss Folding Wing Manual

9 Assembly Instructions

9:1 Loading / Unloading
9:2 Fitting Wing Gangs
9:3 Setting Pull Height
9:4 Setting Tongue Height
9:5 Tow Bar
9:1 Loading / Unloading
The Field Boss Folding Wing is delivered in
a flat pack configuration. It requires a level
floor area or ground site, the use of a crane,
three adjustable stands, a tape measure and
various spanners to assemble the machine.
1. Unpack the flat pack.
Using a crane, unstack the flat pack and
place the components in a convenient place
on the floor or ground. Use a plan view of
the machine shown in the operator's manual
under plough frame assemblies (see Parts
Section) to familiarise yourself with location of
machine sections. The plough comes with a
tool kit which should be stored in the plough's
tool box when not in use.

2. Assemble the main frame.

Align the two sections of the main frame (or
centre frame) while on the ground and bolt
them together. Fully tighten all the frame bolts.
20
3. Assemble disc gang assemblies to the
main frame.
Follow the assembly instructions below:
a) Position the disc gang assemblies 1, 2 and
3 on the ground to assimilate their correct
position under the main frame. See Section
13.
b) Use 75mm x 75mm (3" x 3") timber blocks
on either side of the discs to chock the discs
and stop the disc gangs moving or rolling
away.
Specifications are subject to change without prior notification
Sling Points
From serial number 6714
Including 6586, 6666, 6703