FLUXWERX View Suspended Install Instructions

Download this manual

IMPORTANT

Read Before Beginning Installation:

• Do not join ﬁ xture lengths together on the ﬂ oor and lift into

place. This introduces signiﬁ cant forces on the joins and will

damage the ﬁ xtures.

• All ﬁ xtures should be installed in accordance with national and

local building and electrical codes.

• Leave the protective bag and care labels on the ﬁ xture during

installation. Warranty is void if labels are removed before

installation is complete.

• Support ﬁ xtures under the lower rail during handling.

TOOLS REQUIRED

Tools:

• Level

• Sharp Side Cutter

• Measuring Tool

• Wire Stripper / Knife

• Phillips Screwdriver

Due to continuous product improvements, speciﬁ cations and dimensions are subject to change without notice. Certain options have

limited compatibility with some other product selections. Consult www.ﬂ uxwerx.com for most current technical information.

604.549.9379 | ﬂ uxwerx.com

instruction

VIEW SUSPENDED

HANDLING

Leave bag and

care labels in place

INSTALL CEILING DRIVER ENCLOSURE

Refer to Driver Enclosure Installation Documents

+ Row Conﬁ guration Document

Install ceiling driver enclosure and aircraft cable suspension per

appropriate ceiling type installation instructions — noting the ﬁ xture

spacing and that the non-power suspension point is NOT the end

suspension point.

install

Warranty void if removed

before installation

Lift from below

Install-View | 2020-03

PAGE 1 of 4

Page 1 — noting the ﬁ xture spacing and that the non-power suspension point is NOT the end suspension point. All rights reserved. © Fluxwerx Illumination 2020 604.549.9379 | ﬂ uxwerx.com PAGE 1 of 4 Due to continuous product improvements, speciﬁ cations and dimensions are subject to change without notice. Certain options have limited compatibility with some other product selections.
Page 2 ﬁ xture and press them together. 2. Level the end of the ﬁ xture by adjusting the aircraft cable in the gripper. All rights reserved. © Fluxwerx Illumination 2020 604.549.9379 | ﬂ uxwerx.com PAGE 2 of 4 Due to continuous product improvements, speciﬁ...
Page 3 DRYWALL APPLICATIONS: INSTALL CANOPY For T-bar ceilings: Close the wiring lid. For drywall ceilings: Lift the canopy into place and tighten the sleeve. All rights reserved. © Fluxwerx Illumination 2020 604.549.9379 | ﬂ uxwerx.com PAGE 3 of 4 Due to continuous product improvements, speciﬁ cations and dimensions are subject to change without notice. Certain options have limited compatibility with some other product selections.
Page 4 2. Fixture can be operated as normal with the bag on. 3. Tear bag at perforation, do not use knives or tools. All rights reserved. © Fluxwerx Illumination 2020 604.549.9379 | ﬂ uxwerx.com PAGE 4 of 4 Due to continuous product improvements, speciﬁ...