Advertisement
READOUT CONSOLE
The readout console for your mini stepper has two user buttons. The readout console also has
a power save function where the console will automatically power down after several minutes of
non use, and will turn on again when a button is depressed or exercise recommences.
START/STOP BUTTON: This button can be depressed to pause the timer during an exercise
session, and will start again when button is pressed again to resume exercise.
RESET BUTTON: This button can be held down for three seconds to reset.
During Exercise, the console screen will display the following:
COUNTER: The counter displays and accumulates the number of strides taken during an
exercise workout (two steps equals one stride)
TIMER: The timer shows the duration of the exercise workout from the point of
commencement.
STOP: The STOP icon will appear on the screen when the start/stop button has been pressed
during a workout session, and will not be visible when exercise recommences.
REPLACING BATTERY:
1. Remove the battery cover on the back of the computer.
2. Replace two 1.5V (AA) batteries.
3. Make sure the batteries are installed correctly and the polarities are correct.
4. If the display is not clear or only partial segments appeared, remove the batteries and wait for
15 seconds before re-install them.
5. Battery life will vary depending on the standard of battery installed in the console.
6. When the batteries are removed, all the functional values will reset to zero.
Note:
Please note all values on this computer are approximate and they are for comparison
purpose only. Do not use these values for any medical or rehabilitation purpose.
Page: 5
Advertisement
