Sensio SIGMA S-BEND FLEXIBLE STRIP Installation Instructions

Installation
INSTRUCTIONS
IMPORTANT: please read these instructions before commencing installation and retain for future reference.

Components

1x Sigma Flexible Strip

Important safety information

Please read these instructions carefully before attempting to
install this product. It is advisable to keep these instructions in a
safe place for further reference.
We recommend that you consult a qualified electrician. All
electrical installations must be carried out in accordance with
current IEE wiring regulations (BS7671).
These products must not be modified, if any modifications are
made it may invalidate the warranty and may render the product
unsafe. These LED lights operate low voltage (24V).
Do not wire the individual LED light fittings directly to the mains.
This fitting is for indoor use only (IP20 rated).

Safety instructions

1. Before commencing installation or maintenance, please clear
the surrounding area of any trip hazards or sharp objects.
2. This product is only suitable for connecting to a 24V DC supply.
3. The light should be mounted onto a secure, clean surface
using the instructions provided.
Waste Electrical & Electronic Equipment (WEEE)
The symbol on the product, or on the document accompanying the product, the crossed out wheelie bin
symbol, indicates that this product may not be treated as household waste. Instead it shall be handed over to
the applicable collection point for the recycling of electrical and electronic waste.
SIGMA S-BEND
FLEXIBLE STRIP

Fitting Instructions

Tools Required

Scissors 6mm Drill Bit
• If in doubt installation must be carried out by a
qualified electrician
• Install on smooth flat surface(s) only
• The strip can be cut and reconnected every 100mm
• The wattage is 18W per 5m reel
• In order to run this product you will need a 2.5m driver
connection cable (SE101080)
• Class III safety extra low voltage (SELV)
4. Never exceed the total output of the LED Driver.
5. Suitable for furniture lighting.
6. If an LED expires the fitting must be replaced.
CODE: SE10255C0/W0
Power Drill