MAGNATRAC MH7000 Operator / Technical Manual page 72

Part Photo
MH-16
Parts Identified
1359 Pulley
1360 Pulley
1361 Belt
1376 Mount, grill
1380 Grill
1382 Mount, pump
1383 Cover
6) To Tension the belt. Using hand
pressure only, slide the #1382
Pump Mount to the right until the
#1362 Belt is drawn tight. Tighten
the four bolts securing the #1382
Pump mount to the engine while
maintaining belt tension.
NOTE: Do not use a pry bar or
leverage device to tighten the belt
as overtightening could result in bearing damage to the pump and/or
engine.
7) Replace the #1383 Cover making sure to install the spacer tubes over the
bolts between the #1383 Cover and the #1382 Pump Mount.
8) Replace the #1380 Grill.
A
Belt Tensioning & Replacement Procedure
1) S h u t o ff tractor, apply parking brake, lower attachments to ground, and remove key.
2) Remove the #1380 Grill. Remove the #1383 Cover by removing the two bolts
1376
1380
1376
B C D
securing it to the #1382 Pump Mount.
NOTE: Spacer tubes are located over these two bolts between the #1383
Cover, and #1382 Pump Mount. Take care to not lose these spacer
tubes during removal.
1383
E F
4) Loosen, but not remove, the four
bolts securing the #1382 Pump
Mount to the Engine.
5) To replace the belt. Slide the
#1382 Pump mount to the left
until belt tension is relieved
enough to allow removal.
Replace the belt.
1359
1376
1382
G H I
1
2
3
4
5
6
1361
7
1360
8
J