Table of Contents
Advertisement
Available languages
Available languages
General Care & Maintenance
Surface Cleaning
Simply use a damp cloth to wipe clean and blot dry with a soft
towel. Use of polish, detergents or harsh abrasives may cause
damage and can void your warranty.
Frequently Asked Questions
Q: How do I know when the filters need to be replaced?
A: It is recommended to replace the filters every 6 months
under normal usage conditions. To set up a convenient email
or text message reminder when it is time to replace your
cartridges, please visit www.PfisterReminder.com.
Q: How do I change the filter cartridges?
A: The GE® filter cartridges are equipped with a "twist & lock" mechanism.
To remove, simply twist the cartridge clockwise and then pull the filter down.
To insert the new cartridge, twist counter clock-wise until the cartridge is locked.
Q: Can this faucet dispense warm and hot filtered water?
A: No. This filter system filters water from the cold water supply line only.
Q: Why is the faucet not dispensing filtered water all the time?
A: Limiting the filter mode to only drinking water use extends the filter life.
Q: Who should I contact with questions about the faucet or the GE filter system?
A: Please contact Pfister Customer Service at 800-Pfaucet (732-8238)
Troubleshooting
Problems
Possible
Causes
GE FIlters
New filter canisters contain
Water containing
activated carbon.
tiny black particles
Air in system after installation.
Cloudy water
or air bubbles
The filter canisters are no longer
Chlorine
reducing chlorine tasteand odor
Taste & Odor
from the water supply.
The filters have been installed
Water slowly
for too long. The filter canisters
have become clogged.
dispensing
Tubing may not be installed
Leaky
properly.
Fittings
Filter canisters not fully installed.
Water not
dispensing
Clarify Faucet
If you are experiencing low flow
Low Flow in
from your faucet while in
unfiltered mode your aerator
Unfiltered Mode
may be clogged
What
To Do...
Turn on the filtered water faucet
and allow to run for 11 gallons (or
approx. 10 minutes) to flush out
any harmless carbon fines present.
Will go away after water runs
for a while.
Replace the filter canisters.
A six-month change-out period is
recommended. Replace both filter
canisters • High sediment levels
can cause premature clogging.
Fully follow the installation
instructions and be sure the tubing
is free of nicks, burrs, etc , and is
installed to the proper depth.
Fully follow the filter replacement
instructions.
Remove and clean the aerator.
Flush your faucet for 15 seconds.
Re-install the aerator.
Advertisement
Table of Contents
