Advertisement
Quick Links
Advertisement
Related Manuals for Fantask EP23484WH
Summary of Contents for Fantask EP23484WH
- Page 1 STAND FAN OPERATING INSTRUCTIONS MADE IN CHINA...
-
Page 2: Important Safeguards
IMPORTANT SAFEGUARDS When using an electrical appliance, basic safety precautions should always be observed, including the following: READ ALL INSTRUCTIONS BEFORE USING WARNING: To reduce the risk of fire, electrical shock, or injury to person: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. -
Page 3: Specifications
Do not attempt to defeat this safety feature. 14.When replacement of Plug, the safety Device（Fuse） is to be reinstalled or remounted as previously installed. FOR HOUSEHOLD USE ONLY SAVE THESE INSTRUCTIONS SPECIFICATIONS MODEL NO RATED VOLTAGE RATED POWER EP23484WH 120V~60Hz STRUCTURE AND PARTS... -
Page 4: Assemble Instructions
ASSEMBLE INSTRUCTIONS The fan is packaged with its foundation and/or other parts unattached. You must attach them before operating the fan. WARNING: Never operate without its foundation and/or other parts attached. Do operate the fan only in upright position; any other position could create a hazardous situation. Assemble sequence of the foundation and other parts as follow: a. - Page 5 e. Take off the motor shaft cover from the fan head, and revolve the triangle screw off, then let three columns into the three holes in place fully, and finally tighten the triangle screw counterclockwise. f. let the notch on the back of the big fan blade stuck in the stopper pin of the motor shaft, and then tighten the small fan blade counterclockwise.
- Page 6 a. Press the button on to start the fan and select the fan speed level, as per the following sequence: 1 The fan speed selecting can be circulated and the speed pilot lamp will be on during the fan operating. b.
-
Page 7: Maintenance
holder over to remove fuse. d) Risk of fire. Replace fuse only with 5 Amp, 125 Volt fuse. e) Close fuse cover, Slide closed the fuse access cover on top of attachment plug or push cover closed so that all tabs latch. f) Risk of fire.