Battery Doctor 23140 Instruction Manual

MOUNTING HARDWARE
To install the mounting brackets on the #23143 and #23144, please follow the below instructions.
Step 1
Remove the screws from the silver bracket on the back
side of the solar panel as shown in the picture. This will
require a 2mm Allen head wrench (included). The screws
that are removed will not be needed to fasten the bracket.
Step 2
Line up the bracket's two holes over the solar panel
bracket's holes and use the supplied Flush Head screws to
secure the bracket to the panel.
Step 3
Repeat these steps for the other three remaining brackets if required.
Please refer to our website for troubleshooting and FAQ's.
www.wirthco.com
WARNING: This product contains chemicals known to the State of California to cause cancer, birth defects or other
ADVERTENCIA: Este producto contiene sustancias químicas que el estado de California causan cáncer, defectos congénitos
u otros daños reproductivos.
Made in China exclusively for Wirthco Engineering Inc.
© 2020 Wirthco Engineering, Inc. All rights reserved.
reproductive harm.
Instruction Manual
1.8 Watt Maintainer
5 Watt Trickle Charger/Maintainer
9 Watt Charger/Maintainer
1.8 Watt Maintainer
(Model #23140)
9 Watt Charger/Maintainer
(Model #23144)
5 Watt Trickle Charger/Maintainer
(Model #23143)