Advertisement
SWAC2-Manual.qxp_Layout 1 09/03/2018 17:57 Page 2
12V
Air Compressor
NOTE: THIS COMPRESSOR OPERATES ONLY ON 12 VOLT DC. DO NOT ATTEMPT TO OPERATE THIS
COMPRESSOR WITH ANY OTHER SOURCE OR VOLTAGE. DO NOT REWIRE OR RECONFIGURE
COMPRESSOR FROM IT'S ORIGINAL DESIGN OR PERSONAL INJURY OR BODILY HARM MAY OCCUR.
Important Safety Information
1.
Compressor: Use 12 volt DC only. Make sure that your vehicle 12V power socket is free of any ash,
residue or debris. A dirty power socket can cause the compressor and power cord to overheat.
Overheating can cause damage to your compressor/vehicle and could cause personal injury (disconnect
power when not in use).
2.
This air compressor is designed to inflate car tyres, bike tyres, ATV tyres, sports equipment, air
mattresses, beach toys and other inflatables. Do not use for any other purpose other than inflating.
If you do so, personal injury can occur.
3.
When operating your compressor do not run for more than 10 minutes of continuous use. Allow
compressor to cool down for 10 minutes before re-using.
4.
After using, turn off power switch (3).
5.
The compressor is not a toy. Keep away from children at all times.
6.
Do not carry compressor by the air hose or power cord, damage may occur.
7.
Do not leave the compressor unattended while in operation.
8.
Do not over inflate. Be sure to follow the manufactures instructions for the item you are inflating.
9.
Keep the compressor away from flammable areas/liquids at all times.
10. Do not operate the compressor in wet or damp areas.
11. Operate the compressor only with the accessories that are included.
To inflate tyres
1.
Move vehicle so that the tyre valve is on the bottom closest to the ground. Place the air compressor
next to the tyre, open the compartment on the rear of the unit and remove 12V cable and air hose.
2.
Place connector on tyre valve stem and push down as far as possible (fig 1). Close the thumb lock.
3.
Plug the 12V power cable into the 12V power socket receptacle (fig 2).
4.
When the correct pressure is reached on the analogue pressure gauge, unplug the power cord.
5.
Remove adaptor from tyre valve, remove the power cord from the cigarette-lighter.
6.
When finished replace 12V power cable and air hose back in the storage compartment.
Fig 1
3 in 1
Fig 2
SWAC2
Advertisement
Table of Contents
Related Manuals for Streetwize SWAC2
Summary of Contents for Streetwize SWAC2
- Page 1 SWAC2-Manual.qxp_Layout 1 09/03/2018 17:57 Page 2 3 in 1 SWAC2 Air Compressor NOTE: THIS COMPRESSOR OPERATES ONLY ON 12 VOLT DC. DO NOT ATTEMPT TO OPERATE THIS COMPRESSOR WITH ANY OTHER SOURCE OR VOLTAGE. DO NOT REWIRE OR RECONFIGURE COMPRESSOR FROM IT'S ORIGINAL DESIGN OR PERSONAL INJURY OR BODILY HARM MAY OCCUR.
- Page 2 Plug power cord into 12V power socket receptacle. When correct pressure is reached unplug power cord. Remove adaptor from inflated article. Remove adaptor from connector. Always check item being inflated with Streetwize pressure gauge. Avoid excessive pressure in low pressure objects. Operating Lights Locate the button on the side of the unit and press the button up marked “FLASH”...
Need help?
Do you have a question about the SWAC2 and is the answer not in the manual?
Questions and answers