Do you have a question about the CART ARMOUR CA-01, CART ARMOUR CA-02 and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for Knaack CART ARMOUR CA-01, CART ARMOUR CA-02
Page 1
CA-01 DESIGNED TO FIT RUBBERMAID CART #4520-88 / #4520-10 CA-02 DESIGNED TO FIT RUBBERMAID CART #9T66-00 CA-03 DESIGNED TO FIT RUBBERMAID CART #9T67-00 RUBBERMAID is a trademark of its respective owner. There is no affiliation, sponsorship or association between Knaack LLC and said owner. CA-01 CA-03 CA-02...
Page 2
DANGER • DO NOT store fuels, flammables or any hazardous materials in this cart. • USE this cart to store and transport electrical tools, hand tools and work related equipment and materials • DO NOT sit or stand on cart or place any ladder or other device to gain additional height above the cart.
ASSEMBLY: BACK PANEL INSTALL: ON A LONG SIDE OF THE CART, LET THE BOTTOM OF THE BACK PANEL REST ON THE LEDGE OF THE CART. USING A CORNER CLAMP ATTACH THE PANEL TO THE BACK PANEL CLAMP, USING TWO CARRIAGE BOLTS AND TWO 1/4-20 WHIZ NUTS.
Page 4
FRONT CORNER CLAMPS: INSTALL THE REMAINING TWO CORNER CLAMPS ON EACH OF THE FRONT CORNERS USING THREE 1/4-20 CARRIAGE BOLTS AND THREE 1/4 WHIZ NUTS. ATTACH THE DOOR LATCH: USING TWO 1/4-20 CARRIAGE BOLTS AND TWO 1/4 WHIZ NUTS. HAND TIGHTEN AT THIS POINT.
Page 5
ATTACH FRONT SIDE PANELS: ATTACH THE FRONT PANEL (WITH DOOR LATCH) TO THE LEFT FRONT LEG OF THE CART. ATTACH THE LEFT SIDE FRONT PANEL USING THREE 1/4-20 CARRIAGE BOLTS AND THREE 1/4 WHIZ NUTS. HAND TIGHTEN AT THIS POINT. REPEAT THE PROCESS ON THE RIGHT SIDE FRONT PANEL.
Page 6
LATCH ADJUSTMENT: ADJUST THE FRONT AND SIDE PANELS SIDE TO SIDE. ADJUST THE DOOR LATCH UP AND DOWN, UNTIL IT IS ALIGNED AND PADLOCK IS ABLE TO BE INSTALLED. LATCH ADJUSTMENT: TEST PADLOCK FOR FUNCTIONALITY. ADJUST AS NEEDED. ONCE ADJUSTED, TIGHTEN THE DOOR LATCH BOLTS USING 7/16”...
Page 7
GROMMET INSTALL (OPTIONAL): CHOOSE WHICH END YOU WOULD LIKE THE GROMMET INSTALLED, THEN USING A HAMMER, TAP ON THE KNOCKOUT AND INSTALL THE GROMMET PROVIDED. PADLOCK STORAGE: BUILT-IN HANDLE: A HOLE HAS BEEN PROVIDED A RECESSED HANDLE HAS BEEN FOR HANGING PADLOCK WHEN BUILT INTO PADLOCK HOUSING.
Need help?
Do you have a question about the CART ARMOUR CA-01, CART ARMOUR CA-02 and is the answer not in the manual?
Questions and answers