Assembly Of The Monitor - Waeco PerfectView CAM26W Installation And Operating Instructions Manual

Collected_RV-HD-Compact_Q4
Rear panel (see E)
8 5-pole plug-in connection (input) for camera 1
9 5-pole plug-in connection (input) for camera 2 (accessory)
10 Selector switch for camera 1 and 2 in order to present the image on the monitor
„normal" or "inverted".
11 Connection for voltage supply
12 Monitor holder
13 Covering caps
Warning! Select the location of the monitor in such a way that the passengers
cannot be hurt under any circumstances (by hard-braking, traffic accident).
The monitor may not hinder the view at any time during the drive (see F 1).
General installation instructions!
Please observe the following points before attaching the monitor:
– Screw the monitor holder onto the monitor.
– Locate the monitor with the attached holder on a trial basis.
– Consider with the selection of the location that you have an unhindered view of the
monitor (see F 2 and F 3).
– The assembly location should be even.
– Check before the final assembly whether the necessary
free space is available, also below the assembly place chosen for the attachment
of discs and nuts.
– Consider the weight of the monitor. Are reinforcements (larger washers or plates)
necessary?
– Is the installation of the connecting cable set and extension cable to the monitor
possible?
You can begin with the assembly if all points have been considered.
Pay attention when locating the monitor that this is not assembled within the
radius of an AIRBAG. Otherwise danger of injury exists when it is being
released.
Pay attention to a possibly large contact area between monitor holder and assembly
ground
Draw the contours of the edges of the monitor holder onto the instrument panel.
Unscrew the monitor holder from the monitor.
Hold the monitor holder within the previously drawn contours and mark at least four
different drilling points (see F 5).
30/06/03 11:00
Function description of the monitor

Assembly of the monitor

38
Page 38