Page 1
MOUNTING FROM THE TOP OF THE MOUNTING SURFACE. Remove the Chassis Plate Screws {C} from the top of the lampset (Figure 1). Figure 1. On a standard Littlite lampset this will enable the chassis plate {A} to be removed from the chassis assembly (Figure 2}. Figure 2.
Page 2
Reattach the chassis and install the chassis plate screws {C}. MOUNTING FROM THE BOTTOM OF THE SURFACE Turn over your Littlite lampset and locate the two threaded posts {B} on the bottom of the chassis plate {A}. (Figure 4) Figure 4.
Page 3
Figure 5. AUTOMOTIVE SERIES LITTLITES Directions for surface mounting L-5 and L-9 automotive series Littlite are identical to the standard lampsets except for the location of the cord set {D} (Figure 6) Figure 6. Because the cord set {D} is routed through the bottom of the chassis plate {A} a hole is required in the mounting surface to accept the cord set and strain relief.