Router Communication / Data Usage - Cradlepoint AER3100 Series Quick Start Manual

Quick Start Guide / AER3100 Series
SETTING THE APN
Depending on your modem, you may need to specify
the APN (Access Point Name). Cradlepoint devices
attempt to auto-detect the correct APN. In most
cases, the APN will be correctly detected and your
device will connect. If your device does not connect
within approximately 5-10 minutes, follow the steps
below to manually enter the APN.
Select the APN
1. Log into the administration pages (see page 4).
2. Select 'Connection Manager'.
3. Select the modem you would like to manage. Click
'Edit' to open the WAN Configuration editor.
4. Select the 'SIM/APN/AUTH Settings' tab. In the
'Access Point Configuration' field, select 'Default
Override' and manually enter the desired APN.
5. Input the username and password for
authentication if required by your carrier.
6. Click 'Submit'.
©2015-2016 Cradlepoint. All Rights Reserved. | +1.855.813.3385
ROUTER COMMUNICATION /
DATA USAGE
The factory default configuration of the router is set
to communicate with Cradlepoint and other resources
at regular intervals to access the latest firmware and
modem updates, clock synchronization (NTP), and
Enterprise Cloud Manager (ECM) membership. Such
communication may result in data usage and applicable
charges regardless of whether the router uses a wired
or wireless Internet connection. To avoid such data
usage and potential charges, consult the following
Knowledge Base article:
knowledgebase.cradlepoint.com/articles/support/
router-communication-data-usage
| cradlepoint.com
7
Part Number: 170661-000