Evolite Infinium 25000 RGB FB4 User Manual page 10

 Unpack and check carefully there is no transportation damage before using the fixture.
 It's important to ground the yellow/green conductor to earth in order to avoid electric shock.
 LASER light can cause permanent eye injuries if eyes are exposed to the laser light.
 Disconnect main power before servicing and maintenance.
 Maximum ambient temperature is: 40℃. Don't operate it when the temperature is higher than this.
 In the event of serious operating problem, stop using the fixture immediately. Never try to repair the fixture
by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the
nearest authorized technical assistance center. There are no user serviceable parts inside the fixture except
the fuse.
 Do not connect the device to any dimmer pack.
 To prevent or reduce the risk of electrical shock or fire, do not expose the fixture to rain or moisture.
 Do not look directly at the LASER light beam while the fixture is on.

Do not touch any wire during operation.
 The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. Always ensure that the structure to which you are attaching
the unit is secure and is able to support a weight of 10 times of the unit's weight. Also always use a safety
cable that can hold 12 times of the weight of the unit when installing the fixture.
 The equipment must be fixed by professionals. And it must be fixed at a place where is out of the touch of
people and has no one pass by or under it.
 Operating Premises: Whenever possible, the operation of a LASER should be done in a room or in an
enclosed or delimited place for this purpose.
 The access of room and openings to the outside must not be located in the axis of a direct beam.
 The floor must be free of obstacles. The causes of accidental reflection and scattering of laser beams must
be removed (misplaced windows, furniture or objects with polished faces).
 The paintings (walls, partitions, ceilings ...) and flooring should preferably be matt. The diffuse reflections of
class 4 lasers, focused beams of lasers of class 3 to visible or near infrared light should be considered
dangerous and treated as such.
 When using powerful lasers (Classes 3 to focused beam or 4), eliminate the beam potential impact on
flammable materials (wood, paper, fabric or plastic) that can be in from fire in power densities of the order
of several W.cm-2 applied for a few seconds.
 The access to the laser emission zones should be reported using the signs in accordance with the Ministerial
Decree of 4 November 1993 "Signs of safety and health in the workplace" and the NF X 08-003 "Symbols
graphics and symbols - colors and safety signs "of December 1994. This signaling is completed by the words
of the class of laser product and the instructions provided in the NF EN 60825-1 standard. Such access can
be controlled, at least when lasers are operating.
 Emissions control: the control panel should be placed outside the locations exposed to hazardous emissions.
The control of lasers in Classes 3 and 4 should be under the control of a key control, removed when the
device is not in use and owned by a qualified person.
 Disclaimer: The use of this device is exclusively for professional activities show and display.
 It is forbidden to allow projecting the beams to the audience and any areas accessible by persons without
appropriate eye and skin protective items. It is forbidden to use this device for any other purpose than that
for which it is intended.
 It is forbidden to shine any laser beam to the aircrafts.
 If the laser is operated in a situation where health or property injury may occur, operation MUST be stopped
immediately!
Infinium 25 000 RGB FB4 User Manual Ver. 1.00 Page 10