Advertisement
Quick Links
INTRODUCTION
GUIDE TO PICTURES & TERMINOLOGY USED FOR INDOOR
TUBULAR MOTORS – Roller blinds, Aero, Vision, Triple
Shade & Trico shade
Control Buttons used for installation :
O
P1 Motor Program Button on 3N & 6N Tubular Motors (Green button)
P1 Motor program button on 1.1N Tubular motor (Small square hole) insert tip of pen or similar to activate motor
ALWAYS ENSURE THAT THE P1 MOTOR BUTTON IS ACCESSIBLE (FACING FORWARDS) WHEN INSTALLING BLINDS
P2 (Found on the back of remote control top left hand side of the battery area)
UP (Found on front of remote control)
STOP − (Found on front of remote control)
DOWN (Found on front of remote control)
CHANNEL SELECTION <
> (Found on front of DD1802H Multi Channel Remote)
To ensure precise limit settings always rotate roller blinds up and down fully before
entering limits to allow fabric to settle properly after transit.
Advertisement
Summary of Contents for abc Aero
- Page 1 INTRODUCTION GUIDE TO PICTURES & TERMINOLOGY USED FOR INDOOR TUBULAR MOTORS – Roller blinds, Aero, Vision, Triple Shade & Trico shade Control Buttons used for installation : P1 Motor Program Button on 3N & 6N Tubular Motors (Green button) P1 Motor program button on 1.1N Tubular motor (Small square hole) insert tip of pen or similar to activate motor...
- Page 2 SETTING UP MOTOR TO REMOTE CONTROL *IF YOU ARE USING MULTI CHANNEL REMOTE SELECT REQUIRED CHANNEL BEFORE PROGRAMMING* PAIRING MOTOR TO REMOTE Press and hold P1 on Motor – Blind will jog (release button) & beep Press and hold Stop on remote control – Blind will jog (release button)& beep – Blind & Remote are now paired ...
-
Page 3: Reset To Factory Mode
RESET TO FACTORY MODE To clear all settings and return to factory mode Hold the P1 motor button for approx. 14 seconds During this time the blind should have jogged 4 times with a lengthy pause between jogs after the fourth jog release the P1 button – the blind will respond with a series of jogs and beeps and will now be back to factory setting mode and will no longer respond to the remote control. -
Page 4: Using Your Remote Control
P2 BUTTON USING YOUR REMOTE CONTROL REMOTE CONTROL FUNCTIONS CHANNEL DISPLAY SCREEN BLIND UP BLIND STOP OR PRESS & HOLD FOR MID SETTING LIMIT WARNING BLIND DOWN Button cell CHANNEL SELECT lithium MULTI CHANNEL REMOTE batteries are a danger if swallowed Channel 0 will operate all please keep the... - Page 5 CHARGING LITHIUM BATTERY MOTORS Lithium battery motors are supplied with a charger for each room/area it takes approx. 3-4 hours to fully charge each motor. Charger will show a red light indicator whilst charging This light will turn green when fully charged ...
- Page 6 CHARGING LITHIUM BATTERY MOTORS DM35LE/S 3N LITHIUM BATTERY You will find two wires at the end of the motor the smaller is the signal wire the other is the power lead, connect the charger into power lead. SIGNAL WIRE Please note: After charging the motor has been completed, wires can be tucked away out of site but please ensure they are clear of any moving parts.