Advertisement
SETTING UP MOTOR TO REMOTE CONTROL
*IF YOU ARE USING MULTI CHANNEL REMOTE SELECT REQUIRED CHANNEL BEFORE PROGRAMMING*
PAIRING MOTOR TO REMOTE
Press and hold P1 on Motor – Blind will jog (release button) & beep
Press and hold Stop on remote control – Blind will jog (release button)& beep – Blind & Remote are now paired
CHECK DIRECTION
If blind is moving in the wrong direction hold the UP and DOWN button simultaneously – blind will jog & beep
SETTING TOP & BOTTOM LIMITS
At this stage the blind will move in jog mode - to take out of jog mode hold the desired direction button until the
blind moves at normal speed - when you press stop the blind will revert back to jog mode until the top and bottom
limits are set, allowing you precision setting.
TOP LIMIT
Run blind up to desired top limit press the Stop & Up buttons simultaneously – Blind will jog and beep – Your top limit
is now set.
BOTTOM LIMIT
Run blind down to desired bottom limit press the Stop & Down buttons simultaneously – Blind will jog and beep – Your
bottom limit is now set.
Now that your top and bottom limits are set the blind will now automatically be out of jog mode and moving at
normal speed.
Advertisement
