Advertisement
11. Power supply LED
12. USB port.
13. Next.
14. Previous
15. Play and Pause.
16. To choose play USB or BT source
17. The LEVEL control determines the volume of the headphones signal.
18. The CROSSFADER is used to fade between channels1 and 2.
19. MIC TALKOVER Allows you to lower the level of the input sources so you can talk
them using the DJ MIC
2. REAR PANEL
All of the unit's audio connections are located on the rear panel and supplied as
RCA connectors.
20. Power supply: Only use the power adapter provided with the unit to power the
unit. When connecting and disconnecting the power cord, be sure the power of
the unit is o . Connect the cord to the rear of the unit and then connect it to the
outlet.
21. The HEADPHONES socket allows you to connect your headphones for pre-
listening (PFL signal). For best results, use headphones with an impedance rating
of at least 32 Ohms
22. Use the AMP output to connect the unit to an ampli er.
•
In order to avoid power-up thumps, which can damage your loudspeakers, please
power up your ampli er last. There should be no signal present, e.g. no music
playing, when you turn on your amp. In addition, we suggest that you set all
volume-related controls to "zero" (down) before powering up your system.
Following these precautions will save you from unpleasant and potentially
dangerous surprises.
23. AUX inputs Jack for Line level signals.
24. WIRELESS BT ANTENNA: Please pull the antenna out when using Wireless BT
input.
25. The PHONO inputs for channel 2 and are only for turntable connection.
The LINE inputs may be used for connecting tape decks, CD or MD players etc.
26. The PHONO inputs for channel 1 and are only for turntable connection.
The LINE inputs may be used for connecting tape decks, CD or MD players etc.
www.PyleUSA.com
5
Advertisement
