RF Limited Magnum 1012 Operating Control And Features

OPERATING CONTROL AND FEATURES

Top Panel Features

1. Off/On, Volume: Turn clockwise to turn power on and set desired
speaker volume level.
2. Clarifier: Allows variation of the receive frequency above and below
the set frequency. This control is intended primarily to tune in SSB
signals.
3. Antenna Connector: The Magnum 1012 uses a BNC type connector
for use with the supplied flexible antenna. The stock antenna provides
good overall performance given its size.
4. Microphone and Speaker Accessory Jack: 2.5mm and 3.5mm jack
for connection of optional speaker microphone and headset accessories.

Side and Back Panel Features

1. Function Button (Func): This button allows for activation of the
secondary features, marked in blue text on the front panel controls. To activate a
secondary feature press the FUNC button (the function indicator "FUN" will
appear on the LCD), then press the desired control button.
2. Frequency Up/Down Buttons: When pressed, these buttons are used to select
the desired operating frequency. Press UP to move up in frequency and DWN to
move down in frequency.
3. Push-To-Talk (PTT) switch: The receiver and transmitter are controlled by
the push-to-talk switch. Press the switch and the transmitter is activated. To
receive, release the push-to-talk switch. When transmitting, hold the unit
approximately two inches from your mouth.
4. Battery Pack Lock: Slide this lock up to remove the battery pack from the
radio.
5. Belt Clip: Allows for ease of carrying while attached to user's belt.
6. Flexible Wrist Strap: Place strap around the wrist to prevent accidental
dropping of the radio while holding.
Front Panel Features
1. Memory Load (ML) and Memory Save (MS) Functions: This feature allows
the user to save and recall specific frequency and operating modes. See Memory
Programming and Recall instructions.
Memory Programming "M1 to M5"
1. Select the desired frequency and mode to be saved.
2. Press and release "FUNC" button and then press the "ML/MS" button,
notice the "M" icon blinking on the right side on the display.
3. Then press "SCAN/MENU" button to save in memory M1.
4. Repeat procedures 1 and 2 and save it to "MODE / H/L" button for memory
M2, "STEP / FREQ" button for M3, "CALL / LOCK" button for M4 and "
SQ,MICG,RFG / RPT" for M5.
Memory Recall "M1 to M5"
1. Press ML/MS and then SCAN / MENU button to recall memory M1
2. Press ME/MS and then MODE / H/L button to recall memory M2
3. Press ME/MS and then STEP/ CH/FREQ. button to recall memory M3
4. Press ME/MS and then CH9/19 / LOCK button to recall memory M4.
5. Press ME/MS and then SQ, MICG, RF-G/ RPT button to recall memory
M5.
2. Scan: Allows the radio to automatically scan through all frequencies,
stopping at any frequency that is busy with signals being communicated. It
will remain on that frequency during the conversation, and will not reactivate
scanning until approximately 5 seconds after the communication signal has
ended. To activate, press the "SCN/M/SCAN" button. The word SCAN will
appear on the display. To stop, press the "SCN/M/SCAN" button again.
3 2
CLAR
SPK MIC
4
1.
2.
5.
3.
4.
1
OFF
VOL
6.