Advertisement
Table of Contents
Vinyl Steam Remover
Instruction sheet
Fill the reservoir with plain water / Do not fill above the miximum level indicator (5L)
Screw the tube into the reservoir
Attach the other end of the tube to the handle (don't forget to put the slip cover over the steam-plate)
Plug in the power cord and let the water heat up (10 - 15 minutes for a full reservoir)
Make sure that the reservoir is horizontally level
Take the handle and hold the steam-plate on the surface moving it left to right or top to bottom
Remove the vinyl from the surface by hand
If the vinyl does not come off smoothly; go over the surface again with the steam-plate
You can work for approximately 80 minutes with a full reservoir
Reservoir
Steam hose
Handle
Steam-plate
Advertisement
Table of Contents
Summary of Contents for Spandex Vinyl Steam Remover
- Page 1 Vinyl Steam Remover Instruction sheet Fill the reservoir with plain water / Do not fill above the miximum level indicator (5L) Screw the tube into the reservoir Attach the other end of the tube to the handle (don't forget to put the slip cover over the steam-plate)
- Page 2 Safety instructions! Important • This machine should only be used with clean water • Do not add additives or chemicals to the water • Never point the steam-plate at people, animals or any object that can be damaged by high temperatures •...
Need help?
Do you have a question about the Vinyl Steam Remover and is the answer not in the manual?
Questions and answers