Subscribe to Our Youtube Channel
Related Manuals for mtts Light Meter
Summary of Contents for mtts Light Meter
- Page 1 MTTS Light Meter User Manual Effective date: October 2019 www.mtts-asia.com Issue Number: 01 Version: 02 EN Light Meter. User Manual Issue Date: November 2019...
-
Page 2: Table Of Contents
Contents Company Information Introduction Device Description Warnings Operation Alarm System Cleaning Maintenance and Service Specifications Explanation of Symbols Warranty Policy V-1-02-EN Light Meter. User Manual... -
Page 3: Company Information
Fax: +84 24 3718 8050 This user manual is intended for health care professionals. Email: assistance@mtts-asia.com www.mtts-asia.com The Light Meter is to be operated by qualified personnel only. This manual, all precautionary information, and specifica- PROMETEO SRL tions should be read before use. -
Page 4: Device Description
Device Description Measuring Irradiance The MTTS Light Meter is single measurement unit suitable for over- The MTTS Light Meter is a spectroradiometer that measures the ther- head and bed type phototherapy. It has 2 sensors loc on both sides of apeutic irradiance (radiant power) of neonatal phototherapy lights. -
Page 5: Warnings
Only use this device under the direct supervision of a licensed medical practitioner. 2. Hold the MTTS Light Meter against the infant’s body as near to the umbilical as possible and aim the Light Meter at the center of the Inspect this device before each use to ensure proper phototherapy light (see figure below). - Page 6 If more than one phototherapy light is being used on the infant, take separate measurements for each light and chart 2. Place the MTTS Light Meter in the middle of the lighted side of the each reading. pad or mattress (see figure below). Any disposable covers should be on the pad or mattress.
-
Page 7: Alarm System
Cloth Detergent To clean the Light Meter: 1. Confirm that the Light Meter is off. If it is on, press POWER to turn it off. 2. Dampen the cloth with either the mild soap-and-water solution or detergent, then wipe down all exterior surfaces of the Light Meter. -
Page 8: Maintenance And Service
(irradiance) standard. Because certain calibration factors are stored tection, such as an electrical-grounding wrist strap, when in the Light Meter memory, the Light Meter must be recalibrated at working with internal components. MTTS. The date of the last calibration is labeled on the Calibration Certificate. -
Page 9: Specifications
Specifications Specifications Returning for Service Performance Specifications When sending equipment for service: - Contact MTTS Technical Service for a Return Merchandise Authori- Control Settings zation (RMA) number and the location where the equipment should Wavelength spectrum 440–465 nm be sent. -
Page 10: Explanation Of Symbols
Refer to User Manual before operating this device. IEC 61010-1:2010 - General safety IEC 61326-1:2012 - EMC Do not disassemble Light Meter unless you are an MTTS trained technician or have been instructed to by quali- fied personnel. Keep out of direct sunlight. -
Page 11: Warranty Policy
In addi- try or region. Standard warranty service response time is MTTS at its sole discretion, may elect to provide you with PRODUCT OR THE COSTS OF REPAIR OR REPLACE- tion, you may also have other legal rights under applica- subject to change due to local parts availability. - Page 12 Warranty Card. The date on tion do not solve the problem, you can receive support by your sales receipt is the date of purchase unless MTTS or doing one of the following: Locate and contact your nearest MTTS service pro- your reseller informs you otherwise in writing.
- Page 13 MEDICAL TECHNOLOGY TRANSFER AND SERVICES Co., LTD House No. 26, Alley 41, An Duong Vuong Street, Tay Ho District, Hanoi City, Vietnam Tel: +84 24 3766 6521 Fax: +84 24 3718 8050 Email: assistance@mtts-asia.com www.mtts-asia.com PROMETEO SRL Via Mantova 9 38122 Trento...
Need help?
Do you have a question about the Light Meter and is the answer not in the manual?
Questions and answers