Except as otherwise expressly provided in writing, AAF makes no representation or warranty in connection with explosion hazard equipment, including, but not limited to, the necessity or effectiveness of explosion hazard equipment or to the design, installation, operation, and performance of such equipment.
Page 7
For instance, if an explosion suppression system is being supplied by parties other than AAF, it is incumbent on the user to ensure that the dust collection equipment has been ordered to resist the internal pressure defined by the suppression equipment supplier.
2.5 Rotating equipment The RotoClone LVN will operate with a fan which is installed either on the ground or on the top of the dust collector. The fan wheel rotates at a nominal speed of 3,600 rpm and has the potential to cause severe injury. The fan wheel could be accessed from inside the cabinet through the air inlet if the moisture eliminator is removed, and from outside the cabinet through the fan discharge.
3.2 Purpose and intended use The RotoClone LVN is intended to be used to collect dust that can be explosive, such as metal dusts, dusts that tend to cause dry collectors to have problems, such as oily or moisture laden dust, or dusts that can be easily collected using a water bath.
Figure 1. Cross Section of the RotoClone LVN Impeller. 3.4 Sizes and Arrangements The RotoClone LVN is available in 2 sizes, operating from 1000 to 2000 cfm (1700-3400 m /hr). 3.5 Filter elements There are no disposable filter elements associated with the RotoClone LVN, as the water and impeller acts as the filtering elements.
The RotoClone LVN is shipped fully assembled. PRODUCT RECEIPT AT THE DESIGNATED DELIVERY POINT The people of AAF International take pride in the quality of the products that we supply and it is our intention that our customer’s experience with our products and services be positive and satisfying.
5.3 Inspection on arrival The AAF RotoClone LVN is normally shipped by truck and should be checked for damage that may have occurred in route. Compare the collector(s) received to the description and/or drawing of the collector(s) ordered. Immediately report any differences or missing items from the order to AAF International.
Safe and efficient operation of the RotoClone LVN depends on proper installation. AAF recommends that the ductwork going into the collector be as straight as possible, with at least 5 diameters of straight run recommended. Authorities with jurisdiction should be consulted before installing the RotoClone LVN to insure local installation laws, codes, regulations and procedures are followed.
More frequent cleaning may be required for certain applications. 12.2 Removal of Collected Material In general, the RotoClone LVN is best suited for light or moderate dust loadings such that the interval between each sludge removal is of a reasonable length.
Surging of the RotoClone is a rocking of the water from end to end in the unit. This can be caused by running the unit well below its rated capacity or too high an external pressure resistance. Contact your local AAF sales representative for assistance.
Page 26
AAF Hava Filtreleri ve Ticaret AS Email: redfiltration@aafintl.com Hürriyet Mahallesi Daikin Australia Pty Ltd Yakac1k D-100 Kuzey Yan Yol No: 49/1-2 (AAF Australia & New Zealand Sales Office) AAF, S.A. 34876 Kartal, Istanbul, Turkey 15 Nyadale Road Scoresby Victoria 3179, C/ Urartea, 11...