Belson Outdoors PORTA-GRILL PG-2460-M-R Instruction Sheet

Belson Outdoors PORTA-GRILL PG-2460-M-R Instruction Sheet

Charcoal fired

Advertisement

Model PG-2460-M-R
Section A -

Grill Assembly

1) Turn firebox onto one side and screw each of (4) leg and caster assemblies into threaded couplers.
2) Attach grill supports to firebox using (4) 3/8" - 16 x 1" bolts and nuts provided. Note: Grill support
bolts go through the firebox and then the grill support with the grill support on the inside of the
firebox. Hood pin should face outward.
3) PG-2460-M only
4) Install nickel chrome plated cooking grate.
Section B –

Optional PG-200 Hood Assembly

1) Place inner hood half over rear of grill with handles to the rear, (grill grate supporting hooks face the
front of the grill). Lift ends of hood over 1/2" pivot pins one side at a time.
2) Place outer hood half over inner hood half with handles to the front of the grill. Lift ends of hood over
1/2" pivot pins one side at a time.
3) With front of the hood in half open position, install the thermometer, using the retaining clip provided
to hold the thermometer in placed.
4) Retaining hair pins should be attached to hood pivot pins.
Charcoal Fired PORTA-GRILL®
A) Place liner into firebox.
B) Place (3) charcoal grates into liner inside firebox.
www.belson.com
111 North River Road
North Aurora, IL 60542
Phone: (800) 323-5664
Fax: (630) 897-0573
sales@belson.com
Instruction Sheet

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PORTA-GRILL PG-2460-M-R and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Belson Outdoors PORTA-GRILL PG-2460-M-R

  • Page 1 111 North River Road North Aurora, IL 60542 Phone: (800) 323-5664 Fax: (630) 897-0573 sales@belson.com Model PG-2460-M-R Instruction Sheet Charcoal Fired PORTA-GRILL® Section A - Grill Assembly 1) Turn firebox onto one side and screw each of (4) leg and caster assemblies into threaded couplers. 2) Attach grill supports to firebox using (4) 3/8"...
  • Page 2 Section A – Grill Assembly PG-2460G Nickel Cooking Grate PG-MGRATE Liner Grate (For PG-2460-M Only) PI-LINER Liner (For PG-2460-M Only) Right Grill PG-I-FB 2’ x 5' Fire Box Left Grill PI-PBCSTR Pipe Leg & Caster www.belson.com...
  • Page 3 ASSEMBLY INSTRUCTIONS ROLL & LOAD CABINET WITH ROTO-BARBECUE ROTISSERIE When installing the Roll & Load Cabinet to any PORTA-GRILL  already in use, the following three steps must be performed before installation of the Roll & Load Cabinet. 1) Remove PG-200 Bread-Box Hood if so equipped. 2) Remove nickel-plated cooking grate.
  • Page 4 www.belson.com...

Table of Contents