PupGear Original doggydocks Installation Instructions

Original doggydocks
See page 3 for proper
attachment
Installation Steps
1. Install Mounting Kit on Dock, Boat or Swim Platform.
(See Instructions Page 2)
2. Place Dowel and stabilizers bars on folding models.
3. Attach Extension Kit using Stabilizer Bars and Supplied Screws.
4. Install Eye Screws to Side of the doggydocks Board.
5. Place Snapbag on Underside of doggydocks.
doggydocks® Models
Folding doggydocks
®
3/8" Dowel for
Folding Model-Place
Inside Second Hinge
NOTE:
Stabilizer Bars Do Not Float!
We recommend securing
with a strap when in use.
INSTALLATION
INSTRUCTIONS
Jumbo doggydocks
®
Stabilizer Bars
(For Folding Model
and Extension Kit)
Installing Stabilizer Bars:
Fold the doggydocks until the
middle hinge is visible.
Place the 3/8" round dowel in
the fold of the second hinge.
Straighten out the doggydocks
and center stabilizer bars with
hinge. Press firmly to make sure
board is locked.
doggydocks®
Extension
Use stabilizer bars to join
doggydocks and ®
extension piece. Install
screws in pre-drilled
holes.
®
Screw Eye Hook
to side of board
Adjust length of rope
for proper float angle.
Floatation Buoys
For Jumbo doggydocks
®
Snapbag™
for All Models