Summary of Contents for NeedleSmart Professional
- Page 1 Needle Destruction Device NeedleSmart™ Professional User Manual - Revision 1 Original Version...
-
Page 3: Table Of Contents
Power Ratings ....................8 Charging ......................8 Error Messages....................8 Markings......................8 Approved Standards ..................9 WEEE ......................... 9 Spares ........................ 9 Cleaning Kit ....................... 9 Warranty ......................9 Contact Information ..................9 Page | 1 NeedleSmart Pro Manual, Revision 1... -
Page 4: Product Description
Product Description The NeedleSmart™ Professional (NS Pro) device employs advanced technology to process and melt hypodermic sharps or needles, rendering them non-sharp and suitable for safe disposal in accordance with local practices. Warnings ⚠ • This device is intended for use by responsible users only, and is not to be used by children. -
Page 5: Parts Diagram
Parts Diagram Description (replaceable part no.) Display Button Outer Shell Charging Port Quartz Tube (72_000080) Melt Electrode Inner Body Outer Shell Retaining Clips Power ON/OFF Switch Page | 3 NeedleSmart Pro Manual, Revision 1... -
Page 6: Display
⚠ CAUTION - Needle will be SHARP Operation It is required by NeedleSmart Ltd. that any operators of the NS Pro are adequately trained in its operational procedure by reading the instructions contained within this manual before use. Before operation, check that... - Page 7 10 minutes. Remove blunted needle and follow appropriate disposal procedures, as determined by local clinical waste disposal protocols. ⚠WARNING: Needle metal may still be hot. Do NOT touch needle after processing. Page | 5 NeedleSmart Pro Manual, Revision 1...
-
Page 8: Cleaning
As with any advanced electronic device, your device will benefit from regular cleaning. The frequency with which you clean the device is dependent on usage and the duty cycles to which it is exposed. Page | 6 NeedleSmart Pro Manual, Revision 1... -
Page 9: Service Position For Replacement Of Quartz Tube
Service Position for Replacement of Quartz Tube It is recommended by NeedleSmart Ltd. that the quartz tube be inspected for damage on a weekly basis and replaced if there are any visible signs of damage. As a minimum requirement, the quartz tube should be changed every 3 months. To remove the quartz tube, the device must first be switched into service mode. -
Page 10: Dimensions
Restriction of Hazardous Substances If the device enters a fault state, an Error Disposal Of WEEE Message will be displayed. Please contact User Instructions NeedleSmart Ltd and request Technical Support – please supply details and quote Error Manufacturer Website Message. Country of Origin... -
Page 11: Approved Standards
NS Pro products are warranted to be free from BS EN 60335-1:2012 defects in materials and workmanship at the BS EN 61326-2-1:2013 time of delivery. NeedleSmart Ltd accept no liability for any defect arising from wilful BS EN 60601-1 (Included charger only) damage, negligence, misuse, abnormal working... - Page 12 +44 (0)151 315 0460 General Enquiries: +44 (0)845 474 6250 ©2018 NeedleSmart. All rights reserved. NeedleSmart, the NeedleSmart Logo and NS Pro are registered and/or unregistered marks of NeedleSmart Ltd or its affiliates. Page | 10 NeedleSmart Pro Manual, Revision 1...
Need help?
Do you have a question about the Professional and is the answer not in the manual?
Questions and answers