Prorack Voyager Shade Awning PR3215 Instructions Manual

FIRST TIME INSTALLATION
• Please read instructions carefully before installation.
• Check the contents of kit. Contact your Prorack dealer if any parts appear to be missing or damaged.
• Clean your roof racks prior to fitting the Shade Awning.
• Take care when opening the box with a knife not to slice through the canvas.
• Once your Awning is unpacked, unzip the awning to find your fitting kit.
• Always secure the awning with pegs and guy ropes. Failure to do so may result in injury as well as damage
to the product and your vehicle if the awning is lifted by unexpected wind.
IMPORTANT WARNING!
IT IS CRITICAL THAT ALL PRORACK RACKS AND ACCESSORIES BE PROPERLY AND SECURELY ATTACHED TO YOUR VEHICLE.
IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR
DEATH TO YOU OR TO OTHERS. YOU ARE RESPONSIBLE FOR SECURING THE RACKS AND ACCESSORIES TO YOUR CAR,
CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR,
AND DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS SUPPLIED WITH
YOUR PRORACK PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND
CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY FAMILIAR WITH THE INSTALLATION
PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER SUCH AS A ROOF RACK
SPECIALIST.
KIT CONTENTS
Item # Component
1 Shade Awning 2 x 2m
2 Awning Bracket
3 Pegs
4 Guy Rope
5 M8 Spring Nut
6 M8 T-Nut
7 M8 Washer
8 M8 Spring Washer
9 M8 Socket Head Capscrew 25mm
10 M8 Socket Head Capscrew 20mm
11 M6 Hex Bolt
12 M6 Washer
13 M6 Nylock Nut
14 6mm Allen Key
09-13-577 Rev 1
PR3215 VOYAGER SHADE AWNING 2 X 2M
9
Qty
1
8
2
2
2
1
4
4
8
4
4
11
4
4 14
4
4
1
Installing Shade Awning direct to Prorack HD,
TOOLS REQUIRED
Tradesman and other Heavy Duty Crossbars
• Tape measure
Go to Step 1
• 10mm Spanner
• Torque Wrench
Installing Shade Awning direct to Prorack S-Wing
(optional)
and International T-Slot Crossbars
Go to Step 7
Installation of Shade Awning plus Recovery Tracks
Carrier Mounting Brackets (PR3207) on Prorack
HD, Tradesman and other Heavy Duty Crossbars
Go to Step 13
Installation of Shade Awning plus Recovery Tracks
Carrier Mounting Brackets (PR3207) on Prorack
S-Wing and International T-Slot Crossbars
Go to Step 21
Set-up and Pack-up of Shade Awning
Go to page 9
10
4
7
3
5
12
13
6
Page 1 of 11