Whirlpool ED25SM Use And Care Manual page 7

, . . - . . , - 1. . .- , , , , j,.. , . . . .
TIPS
l
The dispensers will work only wrth the freezer
door closed.
l
The ice dispenser will work only if the btn IS
pushed all the way In.
l
Use only ice crescents trom the ice maker.
'
Other shapes won't dispense properly
l
When you need more ice than a glass or
two. scoop It from the brn or remove the brn.
The dispenser motor may stop if the dis-
penser bar is held In too long It will be ready
to run again In about 3 minutes
l
Ice stored too long can go stale .Irke water
Throw it away.
l
Ice can shrrnk. Cold moving air slowly evap-
orates them. If you use Ice often, you may
never notrce the change.
._,,. ,~,
Plan to remove and empty the storage bin:
l
If the ice dispenser has not, or WIII not be used for a
week or more;
l
If a power farlure causes ice in the bin to melt and
freeze together,
l
If the Ice dispenser
IS
not used regularly.
1 Pull the covering panel out from the bottom and
slide It to the rear.
III
OFF/ON Slgnal Arti
2 Lift the stgnal arm so it clicks tnto the OF
Ice can still be drspensed, but no more will
:F position.
be made.
3. Lift the front of the storage bin. Pull It out.
4. Empty the bin Use hot or warm water to melt the
ice if necessary Never use anythlng sharp to break
up ice In the bin This can damage the brn and
dispenser mechanism
5. Wash with mild detergent Rinse well.Do not use
harsh or abrasive cleansers or solvents.
6 When replacing the bin, make sure it is pushed in
all the way Push the signal arm down to the ON
position to restart ice production.
The nlght light uses a heavy-duty IO-watt bulb. It
should last about 10,000 hours When It burns out.
purchase another from your dealer.
7