Bottom Bobbin Placement; Sewing Instructions - Kasanova CIH000005 Instruction Manual

SEWING MACHINE AND SEWING KIT
spindle and guide it through the hole in the bobbin and replace the spindle.)
3. Pull the thread from the spool through the first thread guide (1) in the di-
rection toward front of machine.
4. Bring thread across to the second thread guide (2) Thread goes over the
tension adjusting screw and must be positioned between the 2 washers
behind the tension adjusting screw. This what provides the lock stitch ten-
sion to the thread.
5. Pull thread from the tension adjusting screw guide through thread guide(3).
6. Pull thread toward thread guide (4) through the take up lever hole.
7. Pull thread down to thread guide (5) and insert thread from the top
downward.
8. Pull thread downward through thread guide. lf necessary, lower the ne-
edle to reach this thread guide by turning the hand wheel slightly coun-
ter-clockwise to lower the needle.
9. lnsert thread through eye (6) of the needle from the front towards the back
of the machine(use the included threader if necessary).
10. Raise the presser foot by lifting up to the lever at the rear of the machine.
11. Pull about 10 inches of thread through the needle and leave it on the deck
under the presser foot towards the back of the machine.

BOTTOM BOBBIN PLACEMENT

1. Remove bobbin cover and place the bobbin with thread of your choice in
the bobbin holder leaving about 10 inches of thread extended out from the
bobbin holder and replace the cover.
2. Turn hand wheel counterclockwise (towards you).The needle will go down,
picking up the bobbin thread. Turn hand wheel until needle has descended
completely and came up again to its highest raised point.
3. Raise the presser foot and bring the spool thread around to the front. Pull it
gently up and you will see it has caught the bobbin thread. Pull the two thre-
ats towards the back(away from you )and lay them under the presser foot.
Note: Make sure that machine was threaded properly, before you begin to sew.
Note: The machine comes pre-threaded; take a minute to review how it's done
to make it easier when you do it yourself.

SEWING INSTRUCTIONS

1. Lift the needle above the presser foot by turning the hand wheel slightly in
clockwise direction.
2. Raise the presser the foot by lifting up on the lever in back of the machine
above the presser foot bar.
9