Advertisement
Advertisement
Table of Contents
Summary of Contents for SnapAV WattBox WB-OVRC-UPS-350-6
- Page 1 ™ WB-OVRC-UPS-350-6 QUICK START GUIDE...
-
Page 2: Box Contents
BOX CONTENTS • WattBox UPS • IEC power cord • 4 × rubber feet FRONT PANEL A. AC Power Switch. A short press of less than 1 second turns on the battery backup • outlets (item D). • When battery backup is on and the alarm is sounding, a short press (less than 1 second) mutes the alarm sound until the next AC power loss. -
Page 3: Rear Panel
REAR PANEL G. Feet. H. Mounting Keyholes. SIDE PANEL Power Inlet: Detachable power cord outlet for 3 prong IEC power cord. Circuit Breaker Reset Button: Press this button to restart the WattBox after an overcurrent condition causes it to shut down to protect your gear. K. -
Page 4: Installation
INSTALLATION The 350VA UPS is designed to sit on a desk or floor, or be installed in a structured wiring can. The slots on the back that can also be used to mount it vertically on a wall. Drill two holes, 12cm apart and aligned on a stud in the wall. Connections and setup This UPS is OvrC enabled. -
Page 5: Led Indicators
(when in battery mode). If you are not familiar with OvrC, visit OvrC.com. To find training for OvrC, log in to SnapAV.com, click on the Training tab, and then launch Snap University. -
Page 6: Audible Alarms
AUDIBLE ALARMS The UPS has an audible beep that warns you about the health of your system. Sounds every 10 seconds AC power is not available, and the unit is operating on battery backup. You can mute this alarm by pressing the power button for less than 1 sec. You can use OvrC to disable the beeps if desired. Sounds every second Low battery. - Page 7 IMPORTANT SAFETY INSTRUCTIONS / CONSIGNES DE SÉCURITÉ IMPORTANTES Read and observe the following safety points at all times. NOTICE / AVIS For indoor use only. Internal components are not sealed from the environment. The device can only be used in a fixed location such as a telecommunication centre, or a dedicated computer room.
- Page 8 defeat the grounding feature by using a 3-to-2 prong adapter. If you have questions about grounding, consult your local power company or a qualified electrician. L’UPS doit être branchée à une prise électrique connectée à la terre. Ce connecteur est conçu pour être inséré dans une prise NEMA 5-15 (mise à la terre à trois broches) seulement.
- Page 9 CAUTION – Exposure to Heat / ATTENTION - Exposition à la chaleur Do not expose the WattBox to direct sunlight or place it near wall heaters, space heaters, or in an enclosed space prone to temperature increase. Do not use the device in a confined, poorly-ventilated location; this can overheat the unit, possibly even causing a fire. If used in a small space other than an EIA-standard rack, ensure that there is adequate space around the device.
- Page 10 Ces limites sont pour fournir une protection raisonnable contre les interférences nuisibles dans les installations résidentielles. Cet équipement génère, utilise et peut émettre de l’ é nergie de fréquence radio. S’il n’ é tait pas installé et utilisé selon le manuel d’utilisation, il y aurait des interférences nuisibles aux communications radio.
- Page 11 SnapAV before installing the surge protector. This policy is valid only in the United States and Canada. It is the policy of SnapAV that it will, in its sole discretion, replace, pay to replace at fair market value, or pay to repair, up to the dollar amount specified, equipment that is damaged by an AC power, cable, telephone, or lightning surge while connected to a properly installed SnapAV surge protector.
-
Page 12: Year Limited Warranty
This warranty shall not apply to products which have been abused, modified, or disassembled. Products to be repaired or replaced under this warranty must be returned to SnapAV or a designated service center with prior notification and an assigned return authorization number (RA).
Need help?
Do you have a question about the WattBox WB-OVRC-UPS-350-6 and is the answer not in the manual?
Questions and answers