Summary of Contents for Hanover Brigantine BRIGDN5PCSWSQ-SU
Page 1
Hanover Outdoor Furniture IMPORTANT If you have any problems with this product (missing or damaged parts, assembly issues, etc.), PLEASE DO NOT RETURN TO THE RETAILER/STORE from where you purchased the product. 1‐866‐851‐8438 Please call our Toll‐Free Customer Service Hotline at: Between 9:00 AM and 5:00 PM Eastern Time, Monday through Friday www.hanover‐products.com Or visit our website at: To expedite any future warranty claims, please retain the Instruction Sheet, Warranty Card and receipt for future use. For additional on‐line support on assembly, troubleshooting and care & maintenance of your outdoor furniture, please visit our website at: www.hanover‐products.com. 6/1/2015 (b) ...
Page 2
Dining Table Owner's Manual If you have any problems with this product, DO NOT RETURN IT TO THE STORE CALL OUR CUSTOMER SERVICE HOT-LINE AT 1-866-851-8438 Between 9 A.M. - 5 P.M. Eastern Time, Monday through Friday Page 1of 7...
PARTS LIST PART# DESCRIPTION PICTURE Table top Table leg Support Tube Bolt M6 x18mm Bolt M6 x 35mm Washer Bolt Cover Wrench Page 5 of 7...
Page 6
Assembly Steps: Note: Do not fully tighten bolts until assembly is completed and alignment is correct. Step 1. Carefully place the table top (A) upside down on a non-abrasive surface. Step 2. Assemble the table legs (B) to the table top (A) with bolts (AA) and washer (CC) as shown in figure 1.
Page 7
Step 5. Verify all bolts are securely tightened before use and turn your table right side up. Your table is now ready to use. (Figure 3). Figure 3 Page 7 of 7...
Page 13
Brigantine Round Umbrella 1-866-851-8438 Page 1 of 7...
Page 14
Manufacturer reserves the right to disclaim liability for any aspect of installation and any resulting inconvenience caused by a defective part of a component. Page 3 of 7...
Page 16
PART# DESCRIPTION PICTURE Q’TY Support tube Umbrella w/crank handle Page 5 of 7...
Page 17
Notice: Table and umbrella base are only for constructional reference and sold separately. Figure 1: Step 1: Place the umbrella base under center of table. Step 2: Loosen knob on umbrella base. Step 3: Insert support tube (A) through hole in table and completely into umbrella base. See figure 1 Step 4: Tighten knob.
Page 18
Figure 3 Step 9: slowly turn the handle of umbrella (B) until umbrella is completely open. Warning : Never use umbrella without an umbrella base and matching table. Always leave umbrella in down position when not in use. Never use umbrella in high wind conditions. Damage to umbrella and or table can occur. Page 7 of 7...