Advertisement
Quick Links
PARTS INCLUDED
1. (8X) T-NUT & PLASTIC SPACER
2. (4X) LOCKRACK BASE
3. LOCKING MECHANISM
4. (8X) NUT ATTACHING BASE TO T-BOLT
5. RUBBER BASE PROTECTORS
6. (4X) LOCKRACK ARM
7. SPACE BAR
8. (8X) ADAPTORS
9. TOOLS
LOAD BAR SET UP
ATTACH LOCKRACK BASES TO LOAD BARS
INSERT SPACE BAR
INTO BASES. SELECT
THE DESIRED DISTANCE
YOU REQUIRE FOR YOUR
WATERCRAFT. ALIGN WITH
T BOLT, PLACE THROUGH
BOTH BASES AND SPACE
BAR..
IF THE LOAD BARS ARE
EQUIPPED WITH ACCESSORY
GROOVES SLIDE THE
T BOLT HARDWARE WITH THE
BLACK RING INTO THE LOAD
BAR GROOVE. IF THE LOAD
BARS DO NOT HAVE GROOVES,
THEN USE THE ADAPTER
INSTRUCTIONS BELOW.
SLIDE THE T BOLT TO ALIGN
WITH THE SCREW HOLES IN
THE BASE.
INSTRUCTIONS
TOOLS NEEDED FOR INSTALLATION (INCLUDED)
LOAD BARS MUST BE
POSITIONED AT LEAST
24" OR MORE APART TO
ENSURE STABILITY.
BEFORE MOUNTING THE
BASE ONTO THE LOAD
BAR, PULL THE RUBBER
PROTECTOR FROM THE
BASE.
1. ONCE THE BASE IS PROPERLY
POSITIONED ON LOAD BAR,
TIGHTEN THE BOLTS WITH A
10MM WRENCH.
2. AFTER THE BASE IS TIGHTENED
COMPLETELY TO THE LOAD
BAR, REPLACE THE RUBBER
PROTECTORS WHILE ALIGNING
THE PRE-FORMED HOLE WITH
THE BOLT.
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Lockrack Extendable
- Page 1 YOU REQUIRE FOR YOUR ENSURE STABILITY. WATERCRAFT. ALIGN WITH T BOLT, PLACE THROUGH BOTH BASES AND SPACE BAR.. ATTACH LOCKRACK BASES TO LOAD BARS IF THE LOAD BARS ARE BEFORE MOUNTING THE EQUIPPED WITH ACCESSORY BASE ONTO THE LOAD GROOVES SLIDE THE...
- Page 2 LOADING WATER CRAFT PROPERLY POSITION THE AFTER ALL 4 ARMS ARE IN WATER CRAFT (E.G. PADDLE LOCKED POSITION AND TIGHT BOARD, KAYAK, ETC.) ON TOP GIVE THE BOARD A WIGGLE OF THE BASE. IN MOST CASES, TO MAKE SURE IT IS SECURE. THE WATER CRAFT WILL BE IF THERE IS ANY MOVEMENT, UPSIDE DOWN (SUP FINS...
Need help?
Do you have a question about the Extendable and is the answer not in the manual?
Questions and answers