LOOKING GLASS FACTORY 8K Stand Assembly Manual

Hardware and tools provided
• M8x26mm socket head cap screw (SHCS) (4)
• M6x12 low profile socket head cap screw (4 +1 spare)
• M5x12mm pan head screw (2)
• M8x70mm shoulder bolt (4)
• M8 lock nut (4)
• Split washer (4)
• M6 washers (4 +1 spare)
• M4 hex key
• M6 hex key
Tools required
• Phillips screwdriver
• 1/2" / 13mm open head wrench
Instructions
1. Release the column from the base
• By hand, pull the double column out of its shipping
position in the base.
2. Install the casters
• Turn the base over bottom side up.
• Lock the casters.
• By hand install the four (4) casters with four (4) split
washers, by threading each into receptacles on the
base.
3. Install the double column
• Turn the base over and place with casters on the
ground.
• By hand insert the double column into the base.
Note: The vertical set of holes on the column should
face the back (narrow end) of the base.
Note: The small cross piece at the bottom of the
column must sit flush onto the base.
• Using the M6 hex key and the four (4) M8x26mm
SHCS screws, secure the column to the base plate.
SAFETY
WARNING! Severe personal injury and property damage can result from
improper installation and assembly.
Read the following carefully before proceeding.
• If you do not understand the instructions or have any concerns or questions,
please contact Looking Glass Factory.
DO NOT install or assemble if the product or hardware is damaged or missing.
•
If you require replacement parts please contact Looking Glass Factory.
• This product is ONLY intended for a Looking Glass 8K display - 51.8 lb /23.5kg
• DO NOT use this product for anything other than the original design.
• Using this product with anything heavier than a Looking Glass 8K display
may result in instability causing possible injury.
• DO NOT allow children to climb on or push the stand.
• This product contains moving parts, please use with caution.
• ALWAYS use two (2) people when installing the Looking Glass 8K display onto
the stand.
• ALWAYS use two (2) people when adjusting the height of the stand.
• ALWAYS use two (2) people when moving the stand.
• Looking Glass Factory disclaims any liability for the modifications, improper
installation, or installation other than the Looking Glass 8K display.
X4
Looking Glass 8K
Stand Assembly
X4
X4