Additional Information - Liftware Level Product Handbook

Additional information

Liftware is designed by Lift Labs (of Verily Life Sciences LLC) in South
San Francisco, California.
Made in China.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
•
This device may not cause harmful interference.
•
This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can emit radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause interference to radio communications. However, there
is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and received.
•
Connect the equipment into an outlet different from that to which
the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Caution—Changes or modifications not expressly approved by Verily
Life Sciences LLC could void the user's authority to operate the
equipment.
For U.S. based customers: The latest version of the user guide can
be accessed at www.liftware.com/level/faqs.
SYMBOLS GLOSSARY
The following symbols appear on the Liftware Level handle and
charging connector, and are defined below:
Read important safeguards on pages 4 and 5 of this user
guide before using Liftware Level.
Read all instructions before using Liftware Level.
11