Table of Contents
Advertisement
INSTALLATION
10
REFRIGERANT (FOR R32 ONLY)
How to Install the Unit
SAFETY INSTRUCTIONS
1
READ ALL INSTRUCTIONS BEFORE USE
Measure the space for installation to
WARNING
!
assure a good fit. The air conditioner must
be installed firmly into place to prevent
Your safety and the safety of others are very important.
vibration and noise.
2
Avoid exposure to direct sunlight.
We have provided many important safety messages in this manual and on your appliance. Always
•
read and follow all safety messages.
3
Remove all obstacles from the rear of the
unit. There must be at least 50 cm (20 in.)
This is the safety alert symbol.
!
of cleared space around the rear of the
•
This symbol alerts you to potential hazards that can kill or injure you and others.
unit. Obstacles restricting the airflow may
All safety messages will follow the safety alert symbol and either the word WARNING
reduce the cooling efficiency of the unit.
•
or CAUTION.
4
The unit should be installed with a slight tilt
towards the outside to allow condensed
These words mean:
water to drain. (About 10~15 mm or 1/4
!
WARNING
bubble with Level)
You may be killed or seriously injured if you do not follow instructions.
Technical Safety
Foam
!
CAUTION
•
You may be injured or cause damage to the product if you do not follow instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the
Cooled air
chance of injury, and tell you what may happen if the instructions are not followed.
(Minimum
installation
height is 70cm)
The following symbols are displayed on units.
70-150cm
This symbol indicates that this appliance uses a flammable refrigerant. If the
refrigerant is is leaked and exposure to an external ignition source, there is a
risk of fire.
This symbol indicates that the Operation Manual should be read carefully.
This symbol indicates that a service personnel should be handling this
equipment with reference to the Installation Manual.
This symbol indicates that information is available such as the Operating
CAUTION
!
Manual or Installation Manual.
• The external grille must be exposed outside for
air discharge.
• As the minimum installation height is 70cm.
Please be aware of some old buildings may not
meet this requirement of installation height.
.
Fence
Awning
Heat
radiation
10~15 mm
Over 50 cm
1/4 Bubble
Level
SAFETY INSTRUCTIONS
SAFETY INSTRUCTIONS
Drainage (Optional)
The base-pan may overflow due to high humidity.
To drain the excess water, remove the drain cap
from the base pan of the unit and secure the
drain pipe.
1
Remove the rubber cap from the hole
under the base-pan.
2
Press the drain pipe into the hole by
hanging and pushing.
3
Connect the drain hose to the outlet
located on the bottom of the drain pipe.
(You can purchase the drain hose or tubing
locally to satisfy your particular needs.
Drain hose is not supplied)
CAUTION
!
• Take care when inserting the drain pipe.
Push away from the sharp edge to avoid
slipping and injuring yourself.
EN
3
7
EN
.
1
.
2
Advertisement
Table of Contents
