Advertisement
IMPORTANT SAFETY INFORMATION
Please read these instructions carefully before use and retain for future reference.
•
When using electrical appliances basic safety precautions should always be followed.
•
Do not expose the units to moisture or dust and excessive temperatures.
•
The mixer can be powered either by a 9V PP3 type battery or a 12VDC 200mA PSU
(not supplied).
OVERVIEW
•
The mixer is designed to balance the input from 8 line inputs and adjust the outputs
volume to a recording device or amplifier.
WHAT's IN THE BOX
•
Mixer Unit
•
User Manual
OPERATION
•
With the power turned off and all level controls turned to minimum, connect up to four
line level inputs to the input jack sockets on each channel.
•
Connect the outputs to the amplifier or the recording device using suitable cables.
•
Turn the power on and the LED will light.
•
Set the master volume to about half way on each channel and adjust each input level
as required.
•
When the balance is as required, adjust the master volume on each channel to suit
the input of the sound system or recording device.
•
The peak LEDs should flash briefly on maximum level but not remain lit.
•
If the peak LED lights for longer, reduce the master volume.
BATTERY INSTALLATION
•
Remove the two screws on the battery cover on the base of the mixer, and remove
the cover.
•
Connect the wiring connector to the battery observing the correct polarity.
•
Insert the battery into the compartment and replace the cover and screws.
MAINTENANCE
•
Clean the outside casing with a soft cloth lightly moistened with mild soap and water.
Never use any abrasive or solvents.
SPECIFICATIONS
Inputs
Input impedance
Output
Output impedance
Output level
Battery
Power Supply (not included)
Dimensions
Weight
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
8 x 6.3mm jack sockets
20kOhms
2 x 6.3mm jack sockets
600 Ohms
+4dB (+8dB max)
9V PP3
12VDC 200mA
150 x 108 x 65mm
637g
2
Made in China. PR2 9PP
Man Rev 1.0
Advertisement
