Safety Instructions - ESYLUX AFR 250 LED 5K Installation And Operating Instructions Manual

INSTALLATION AND OPERATING INSTRUCTIONS
GB
Congratulations on your purchase of this high-quality ESYLUX product. To ensure proper operation, please read
these user instructions carefully and keep them for future reference.
1 • SAFETY INSTRUCTIONS
CAUTION: work on the 230 V power system must be carried out by authorised personnel only
GB
with due regard to the applicable installation regulations. Switch off the power supply before
installing the system.
μ
= Contact gap < 1.2 mm
Use this product only as intended (as described in the user instructions). Changes or
modifications to the product or painting it will result in loss of warranty. You should check the
device for damage immediately after unpacking it. If there is any damage, you should not
install the device under any circumstances.
If you suspect that safe operation of the device cannot be guaranteed, you should turn the
device off immediately and make sure that it cannot be operated unintentionally.
2 • DESCRIPTION
The OFR 250 and OFR 350 are ESYLUX floodlights with in-built, non-replaceable LED lamps.
The AFR 250 and AFR 350 are automatic floodlights from ESYLUX with in-built, non-
replaceable LED lamps and an integrated 140° motion detector.
ESYLUX motion detectors are passive infrared detectors, which react to moving heat sources
(e.g. people or vehicles). If the motion detector senses a change in thermal radiation inside its
field of detection, depending on the set light value, it will switch on the automatic light for a
preset length of time, as well as additional devices if desired.
Alternatively, the AFR 250 and/or AFR 350 automatic floodlight can be switched off when it
gets light and on when it gets dark. The twilight switch can be used to determine the point at
which this happens.
6
3 • INSTALLATION / ASSEMBLY / CONNECTION
Please observe the following before installing the device:
• Switch off the power supply at the mains before installing the product.
• Any information relating to the motion detector's range is based on an installation height of
2.50 m. (The field of detection will vary depending on the height.)
• To ensure optimum performance (i.e. maximum range), position the device so that people/
vehicles move at an angle to the detector (fig. 1 (1) head-on to the detector (2) diagonally to the
detector).
• Ensure that the detector has a clear line of sight, as infrared beams cannot penetrate solid
objects.
• Take the surrounding area into consideration when installing the device, e.g. neighbouring
plots or the distance to the road.
• The lights should only be installed on a stable, flat surface (e.g. a wall).
The wall base unit and light can be plugged into one another. Disconnect the two components
for installation purposes. Release the locking screw, press in the spring mechanism and remove
the light from the wall base unit (fig. 2.1). Insert the cable and mount the wall base unit as
shown in fig. 3.
Connect the AFR 250 and/or AFR 350 automatic light as shown in circuit diagram fig. 4.
(4.1) Standard operation
(4.2) Standard operation with additional connection of external loads
Connect the OFR 250 and/or OFR 350 light as shown in circuit diagram fig. 5.
(5.1) Standard operation
(5.2) Controlled by automatic lights, such as AFR 250 and/or AFR 350
Push the light into the wall base unit until you hear the spring mechanism click into place and
secure it with the screw (fig. 2.2).
NOTE: The light must always be mounted so that the luminaire head is located at
the upper end of the housing.