+ 0 800 031 0100 Genie, "S" and "Z" are registered trademarks of South America - other + 56 9 6431 2110 Terex South Dakota, Inc. in the U.S.A. and many locations other countries. All other locations + 1 425-881 1800 "TraX"...
Instructions Introduction Tools Required: Theory of Operation 3/8 inch socket ALC-600 software consists of two parts, the application firmware and the bootloader firmware. 7/16 inch socket The only time an operator will enter bootloader mode is when updating the firmware.
Page 4
Press Escape. Press OK to exit bootloader mode. 1 escape button 2 scroll up button 3 scroll down button 4 OK button 5 Settings 6 Faults 7 LED, fault indicator 8 Maintenance 9 Home ALC-600 Software Update Part No. 1295343GT...
Page 5
Note: File systems such as NTFS and exFAT are not supported by the ALC-600 operating system. http://firmware.genielift.com Select the model that is appropriate for your Insert a USB flash drive into a USB port on your computer.
Page 6
Instructions Rev A Procedure How to Enter ALC-600 Software When complete, press OK. Update Mode Note: If the bootloader firmware is also being updated, press Escape. Select the bootloader Open the ground control box. Remove the firmware and follow the on-screen prompts. When retaining fasteners securing the display complete, press OK.
Page 7
Manual located on your machine. red Emergency Stop button to the on position. 12 Return the machine to service. You will be prompted for a password. Enter 3 - 3 - 2 - 4. Part No. 1295343GT ALC-600 Software Update...
Page 8
• How to Calibrate the Primary Boom Angle Sensor • How to Calibrate the Primary Boom Length Sensor 19 Perform function test. Refer to the Operator's Manual located on your machine. 20 Return the machine to service. ALC-600 Software Update Part No. 1295343GT...
Page 9
Drive Ramps CW out of stow max Standard acceleration CCW out of stow max Standard deceleration Torque switching deceleration Turntable Ramps CW acceleration Anti-Stall CW deceleration Threshold CCW acceleration Drive minimum CCW deceleration Range Hysteresis Part No. 1295343GT ALC-600 Software Update...
Page 10
Platform rotate CCW max output Jib & Platform Ramps Jib up/down ramp time Platform level ramp time Platform rotate ramp time Instr ucti ons Part No. 1295343GT ALC- 600 Softw are U pdate Rev A ALC-600 Software Update Part No. 1295343GT...