ION TOTAL PA GLOW 3 User Manual page 8

Connecting Two Speakers
To wirelessly link two Total PA Glow 3 speakers:
1. Power on both speakers using their Power Switches.
2. With no Bluetooth connected, press the Link button on one Total PA Glow 3 to enter Stereo Link Mode.
Then, press the Link button on a second Total PA Glow 3 to begin pairing.
3. Wait up to 1 minute for the speakers to make the connection. Once the two speakers are linked, press
the Mode button on either speaker to select Bluetooth mode and begin the Bluetooth pairing process.
The speaker you use for Bluetooth pairing will serve as the master speaker. Use the directions
connect your Bluetooth device.
4. To disconnect, double-press the Link button on either speaker.
To switch the left and right stereo channels while the speakers are linked, press and hold the Link button.
To link two Total PA Glow 3 speakers using cables:
1. With the Power Switch on each speaker turned to the off position, connect each speaker to a power
outlet.
2. Plug an XLR cable into the Mix Out located on the rear panel of one Total PA Glow 3 speaker. This
speaker (the master) is the one to which you will connect audio sources such as a Bluetooth device,
microphone, or USB flash drive.
3. Plug the other end of the XLR cable into the XLR Input on the rear panel of your second Total PA Glow
3 speaker. This second speaker will receive the audio from any devices connected to the first speaker
(the master).
4. Power on both speakers using their Power Switches.
5. Connect your audio sources to the first speaker (the master).
6. Make sure that each speaker's Master Volume control is set to the same position.
7. With one of your audio sources playing, gradually turn up the Aux Input Volume on the second Total PA
Glow 3 speaker until the volume of this speaker matches the volume of the first speaker (the master).
8
above to