Advertisement
(2) Connecting the Spindle and Gear Set [14] and the
electrical components assembled as described in
Para. (1)
When connecting the Spindle and Gear Set [14]
and the electric components assembled as
described in Para. (1) above, ensure that the
colored lead wires soldered to the Motor [21] are
correctly positioned with relation to the notched
portion of the Spindle and Gear Set [14] before
fastening the two sections with the four D3 x 8
Tapping Screws [18]. (See Fig. 9)
(3) Reassembly of the clutch section
Assemble the Cap [9] and Shift Arm [15] onto the Spindle and Gear Set [14]. (See Fig. 10)
During assembly, be very careful not to allow the four Steel Balls [13] to drop out of the Spindle and Gear Set
[14].
(a) When assembling the Spring Holder [10] onto the Spindle and Gear Set [14], ensure that the notched
portions of the Spindle and Gear Set [14] are properly aligned with the matching protruding portions of the
Spring Holder [10]. (See Fig. 11)
[9]
Protruding portion
[11]
[12]
[10]
White lIne
Fig. 10
Protruding portions
Notched portions
Fig. 11
Notched portion
Tapping Screw
D3 x 8 [18]
[15]
[14]
[13]
Notched portion
−3−
Spindle and Gear Set [14]
Internal wire (yellow)
Motor [21]
Fig. 9
Internal wire
(yellow)
Advertisement
