Page 1
RockCrusher ™ Owner’s Manual Version 1.0 Dec. 01, 2010 Power Attenuator and Load Box Rivera Amplification. Burbank, California, USA...
Page 2
North America, Germany, and Japan. With correct use and care, you will experience many years of enjoyment with the RockCrusher. It is an invaluable tool on stage as well as in the studio. WARNINGS! PLEASE READ BEFORE USING!
Page 3
Load Box function, and is recommended for extended Load Box use. Do not use the RockCrusher on amplifiers that are hard-wired for 2 or 4 ohms, or do not have 8 or 16 Ohm Output impedance capability.
Input From Amplifier: Connect this jack to the output of your amplifier. Be sure to set the impedance on your amplifier to match the the impedance of the RockCrusher Z Selector on the front panel, as well as the speaker(s) connected to the Speaker jacks. Use only proper speaker cables.
4. Connect the Speaker jacks of the RockCrusher to your speaker cabinets with a proper speaker cable (see above). If you wish to use the RockCrusher as a Load Box, be sure the front panel Function switch is set to Attenuator position.
RIVERA Authorized Service Station, by returning the unit to the RIVERA factory with prior authorization, or (in countries outside of the United States) by a representative RIVERA distributor. A list of RIVERA Authorized Service Stations can be obtained from RIVERA, 508 S.
Page 7
The foregoing is in lieu of all expressed warranties, and RIVERA does not authorize any party to assume for it any other obligation or liability. In no event shall RIVERA be liable for special or consequential damages arising from the use of this product, or for any delay in the performance or this warranty due to causes beyond our control.