Summary of Contents for Hydrotek Active Aqua Chiller, 1/10 HP
- Page 1 INSTRUCTIONS WATER CHILLERS Active Aqua Chiller, 1/10 HP Active Aqua Chiller, 1/4 HP DISTRIBUTED BY ® www.hydrotek.ca...
-
Page 2: Performance Curve
Water inlet & outlet adaptor Handle Switch Socket Tank (with evaporator) Base Compressor Fan motor Condenser Water temperature sensor Filter (front cover) Front cover PERFORMANCE CURVE THE REFRIGERATION PERFORMANCE TEST IS INDICATED WHEN THE AMBIENT TEMPERATURE IS 86°F 1/10 HP www.hydrotek.ca... -
Page 3: Specifications
13 - 50 GAL (50-190 L) Weight 34 lbs Size 16.5 " x 10 " x 14.5 " * The BTU is measured at an ambient temperature of 97°F (36°C) and the Chiller is working at 1100W/9.6A power. Recommended Pump: 160 or 250 GPH www.hydrotek.ca... - Page 4 Front trim cover Circuit board Back cover of circuit board Seal sleeve Condenser Back cover Handle Compressor Base Tank (with evaporator) Top cover PERFORMANCE CURVE THE REFRIGERATION PERFORMANCE TEST IS INDICATED WHEN THE AMBIENT TEMPERATURE IS 86°F 1/4 HP www.hydrotek.ca...
- Page 5 52 GAL to 132 GAL. When reservoir capacity falls, the water temperature will drop faster. * The BTU is measured at an ambient temperature of 97°F (36°C) and the Chiller is working at 1100W/9.6A power. Recommended Pump: 250 or 550 GPH www.hydrotek.ca...
-
Page 6: Circuit Diagram
• The compressor protection device system is built to shut off the circuit automatically to prevent the motor from burning out when the motor is overheating • Temperature memory system that allows the chiller to refrigerate continuously according to the previous temperature setting www.hydrotek.ca... -
Page 7: Suggestions For Safe Operation
INSTRUCTIONS INTRODUCTION SUGGESTIONS FOR SAFE OPERATION TERMS AND SYMBOLS WHERE TO INSTALL www.hydrotek.ca... - Page 8 INSTRUCTIONS ASSEMBLY INSTRUCTIONS www.hydrotek.ca...
-
Page 9: Operation
INSTRUCTIONS OPERATION WARNINGS: SETTING THE TEMPERATURE: TEMPERATURE DISPLAY: TEMPERATURE ERROR ADJUSTMENT: www.hydrotek.ca... -
Page 10: Compressor Operation
INSTRUCTIONS COMPRESSOR OPERATION: ERROR CODE: CLEANING AND MAINTENANCE www.hydrotek.ca... -
Page 11: Troubleshooting
Reset temperature decreased or there is no temperature refrigeration Clean the air inlet/outlet with a brush The air inlet or outlet are clogged or a vacuum cleaner Loud Operation Not installed on a flat surface Reinstall correctly www.hydrotek.ca... -
Page 12: Limited Warranty
WARRANTY LIMITED WARRANTY GARANTIE LIMITÉE GARANTÍA LIMITADA www.hydrotek.ca... - Page 13 2. Plug the chiller into a grounded outlet and ensure the power switch located on the back of the unit is in the “ON” (I) posi on. www.hydrotek.ca...
- Page 14 Over me, nutrient deposits and other debris may accumulate inside the chiller, impeding the operability. To prevent clogging and minimize maintenance, we recommend use of our 6" or 10" filter bag with your submersible pump. www.hydrotek.ca...
- Page 15 We recommend that the power source support ONLY the chiller unit and no addi onal appliances in order to prevent a power surge or circuit overload. Remote operation of the chiller unit outside of the grow space will reduce the amount • of heat generated within the garden. Warnings: www.hydrotek.ca...
- Page 16 "Spare Fuse". STEP 7 STEP 8 STEP 9 "Spare Fuse" "Fuse in Use" Remove "Spare Fuse" from side Insert the "spare fuse" into the Insert fuse cover and push in. "fuse in use" slot. compartment. ® www.hydrotek.ca...
Need help?
Do you have a question about the Active Aqua Chiller, 1/10 HP and is the answer not in the manual?
Questions and answers