Advertisement
Quick Links
Advertisement
Summary of Contents for NCR 7761-K120
- Page 1 KIT INSTRUCTIONS 90W/150W Power Supply Release 1.0 7761–K120/7743–K331 Issue A...
-
Page 2: Revision Record
NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current. -
Page 3: Kit Content
90W/150W Power Supply Introduction This kit provides a 90W, 19V or 150W, 24V Power Supply. Kit Content... -
Page 4: Installation Procedure
7761 - K120/7743-K331 (Power Supply) Installation Procedure P–Series Stand 1. Pivot the display toward the back. 2. Remove the Upper Stand Cover by pivoting it away from the stand. The cover has a simple snap fit connection at the top. - Page 5 7761 - K120/7743-K331 (Power Supply) 3. Loosen the Thumbscrew that secures the Base Cover. 4. Slide the Base Cover toward the front slightly to disengage it from the Base.
- Page 6 7761 - K120/7743-K331 (Power Supply) 5. Route the AC Power Cord up through the base of the stand. 6. Attach the Power Cord to the Power Brick. 7. Install the Power Brick in the Base.
- Page 7 7761 - K120/7743-K331 (Power Supply) 8. Loosen the thumbscrew to open the Cable Door. 9. Loosen the screw on the Terminal Cable Cover. To open, press the indentations on the Cable Cover to unlatch the cover then pivot to open.
- Page 8 7761 - K120/7743-K331 (Power Supply) 10. Route the power cable up through the stand and connect the power supply cable to the Power In connector. 11. Secure the excess power cables with a cable tie and place the cables behind the Cable Door.
-
Page 9: Pole Mount
7761 - K120/7743-K331 (Power Supply) Pole Mount 1. Pivot the display toward the back. 2. Loosen the screw on the Terminal Cable Cover. To open, press the indentations on the Cable Cover to unlatch the cover then pivot to open. 3. - Page 10 7761 - K120/7743-K331 (Power Supply) 4. Route the power supply cable up through the pole mount and to the display. 5. Connect the power supply cable to the Power In connector. 6. Close the Cable Cover and tighten thumbscrew to secure cover. 7.