Table of Contents
Advertisement
I
NSTALLATION
Remove security screw on bottom of cover.
Open unit by pulling on bottom side
of Room Controller (fig. 1).
Remove wiring terminals from
sticker.
Read FCC ID and IC label installed
in cover.
Location
1.
Should not be installed on outside
wall.
2.
Must be installed away from any
direct heat source.
3.
Should not be installed near air
discharge grill.
4.
Should not be affected by direct
sun radiation.
5.
Nothing should restrict vertical air
circulation to the Room Controller.
Installation
1.
Swing open Room Controller PCB
to left by pressing PCB locking tabs
(fig. 2).
Pull out cables 6" out from wall.
2.
Ensure wall surface is flat and
clean.
3.
Insert cable in central hole of base.
4.
Align base and mark location of two
mounting holes on wall ensuring
proper side of base up.
5.
Install anchors in wall.
6.
Insert screws in mounting holes on
each side of base (fig. 2).
7.
Gently swing back circuit board on
base and push until tabs lock.
8.
Strip each wire 1/4 inch from end.
9.
Insert each wire according to wiring
diagram.
10. Gently push excess wiring back into
hole (fig. 3).
11. Re-Install wiring terminals in correct
locations (fig. 3).
12. Re-install cover (top side first) and
gently push extra wire length back
into hole in wall.
13. Install security screw.
2 | 028-0229-05
November 2015
Advertisement
Table of Contents
