Advertisement
INSTALLATION OF EZI-TURN
IMPORTANT OH&S SAFETY WARNING
Trailer king pin to fifth wheel mismatch is not uncommon & fitting of an EZI-TURN* may in-
crease the possibility of mismatch. It is therefore IMPORTANT that these fitting instructions are
read & understood prior to commencing installation. Do not hesitate to contact Ezi-Products
with any query concerning installation or on-going use.
Advertisement
Table of Contents
Summary of Contents for eZi EZI-TURN
- Page 1 INSTALLATION OF EZI-TURN IMPORTANT OH&S SAFETY WARNING Trailer king pin to fifth wheel mismatch is not uncommon & fitting of an EZI-TURN* may in- crease the possibility of mismatch. It is therefore IMPORTANT that these fitting instructions are read & understood prior to commencing installation. Do not hesitate to contact Ezi-Products...
- Page 2 1 drill bit Clean fifth wheel. Remove all grease and foreign material. Centre EZI-TURN* bearing on top of fifth wheel from left to right & front to back. Clamp into position using ‘G’ clamps or vice clamps. Using the drill bit, spot all holes on the flat surface of the EZI-TURN* bearing.
Need help?
Do you have a question about the EZI-TURN and is the answer not in the manual?
Questions and answers