Neat Acoustics Iota XPLORER Instructions For Use

The Iota XPLORER Loudspeaker
INSTRUCTIONS FOR USE
Congratulations on choosing the Neat Iota Xplorer loudspeakers. Used correctly, they will provide a lifetime of beautiful
music. Please read the following notes in order to get the best from them.

RUNNING IN

A 'running in' period of at least 200 hours is necessary to stabilise performance. After this period, a further
gradual improvement will occur over a period of several weeks.

FIRST

The speakers are packed in two separate cartons.
Unpack, and place each speaker on its front on a clean, non-abrasive surface. Fit the supplied end spikes to the cones
on the base of the speaker. Return to upright, place the speaker in required position. Level the speaker by tilting the
speaker and adjusting the spikes. When the speaker is level and stable, the spikes are automatically locked in place.

CONNECTION

The Iota Xplorer is supplied with a single set of terminals for 'normal' (single-wire) connection. Just connect the cable
from the amplifier to the terminals, ensuring correct polarity.

POSITIONING

Due to huge variations in the acoustic properties of different rooms, there are few hard and fast rules governing
loudspeaker positioning, and experimentation is recommended. Generally, bass output increases as distance from the
rear wall, or side wall, decreases. Stereo depth improves as the speaker is brought away from room boundaries.
Start with the Iota Xplorer at around 20cm from the rear walls, with at least 50cm from side walls, if possible, with
perhaps a slight toe-in (10-15%). Play a familiar piece of music, with some bass content, make incremental moves in
different directions, noting the changes, until an optimal position is reached. Remember that sometimes very small
movements of the loudspeaker can bring about significant differences in balance and presentation.
The AMT tweeters should normally be positioned on the outsides, though it may be preferable to locate them on the
insides in some situations.

MAINTENANCE

The Iota Xplorer has no user-replaceable parts and requires no maintenance.
To clean the cabinet, brush lightly with a dry sponge. The bass/midrange cone can be cleaned by GENTLY using a soft,
very lightly damp cloth. Do not touch the tweeter diaphragm. Should a fault condition arise, consult your dealer.