Summary of Contents for VentilClima Air Hygienic Series
- Page 1 INSTALLATION, USE, MAINTENANCE MANUAL AIR HYGIENIC CENTRIFUGAL FAN COIL UNIT 2018-1...
- Page 2 INSTALLATION, USE, Vers. 2018-0 centrifugal fan coil unit MAINTENANCE MANUAL ATTENTION! 1) THE FILTER MUST BE KEPT CLEAN 2) CLEAN THE FILTER MAXIMUM FOR TWO TIMES AND THEN REPLACE IT. FURTHERMORE FILTER MUST BE REPLACED WITH A NEW ONE AT LEAST EVERY 12 MONTHS...
- Page 3 INSTALLATION, USE, Vers. 2018-0 centrifugal fan coil unit MAINTENANCE MANUAL INDEX INTRODUCTION RECOMMENDATIONS TRANSPORTATION, RECEIVING, HANDLING SAFETY RULES GENERAL DIMENSIONS DIMENSIONAL CHARACTERISTICS MAIN COMPONENTS RECOMMENDATIONS FOR INSTALLATION FAN COIL INSTALLATION WATER CONNECTIONS Connection to the water mains Condensate water drainage WORK LIMITS ELECTRICAL CONNECTION CONNECTIONS TO THE TERMINAL BOARD...
-
Page 4: Safety Rules
INSTALLATION, USE, Vers. 2018-0 centrifugal fan coil unit MAINTENANCE MANUAL INTRODUCTION TRASPORTATION, RECEIVING, HANDLING This installation, operation and maintenance booklet should always accompany The appliance is dispatched enclosed in special protective packaging, which the fancoil ready consultation by the installer or user if necessary. The appliance should be kept intact until the appliance is positioned in the final place of in- should be installed in compliance with regulations in force in each country and stallation. -
Page 5: General Dimensions
INSTALLATION, USE, Vers. 2018-0 centrifugal fan coil unit MAINTENANCE MANUAL GENERAL DIMENSIONS Pic. 02 * NOTE: the dimensions shown are referred at system with left hydraulic connections DIMENSIONAL CHARACTERISTICS 2 PIPE SYSTEM MOD. Fans number n° Coils numbers n° Rows number n°... -
Page 6: Main Components
INSTALLATION, USE, Vers. 2018-0 centrifugal fan coil unit MAINTENANCE MANUAL MAIN COMPONENTS Pic. 04 FAN COIL INSTALLATION Before installing the appliance, remove the cabinet, if present (Pic.5) and put it in the packing box to prevent it from being soiled or damaged. (Pic.6) Pic. -
Page 7: Connection To The Water Mains
INSTALLATION, USE, Vers. 2018-0 centrifugal fan coil unit MAINTENANCE MANUAL WATER CONNECTIONS CONNECTION TO THE WATER MAINS CAUTION! Always use a wrench and nose key for connection of the coil to the pipes (Pic. 11). If the solenoid valve is installed, suitably insulate the valve body with insulating material (Pic. -
Page 8: Work Limits
INSTALLATION, USE, Vers. 2018-0 centrifugal fan coil unit MAINTENANCE MANUAL WORK LIMITS CONNECTIONS TO THE TERMINAL BOARD WITHOUT CONTROL PANEL The electrical connections should be made to the terminal board on the side of SUMMER (COOLING) the appliance. Each terminal is identified by the label to be found on the terminal board. Minimum inlet water temperature +4°C WITH CONTROL PANEL... -
Page 9: Cleaning And Maintenance
INSTALLATION, USE, Vers. 2018-0 centrifugal fan coil unit MAINTENANCE MANUAL D) Take out drain pan (A). CLEANING AND MAINTENANCE ATTENTION! 1) THE FILTER MUST BE KEPT CLEAN 2) CLEAN THE FILTER MAXIMUM FOR TWO TIMES AND THEN REPLACE IT. FURTHER FILTER MUST BE REPLACED WITH A NEW ON AT LEAST EVERY 12 MONTHS CAUTION! Before carrying out any cleaning or maintenance work, discon- nect the appliance from the mains electricity supply! - Page 10 INSTALLATION, USE, Vers. 2018-0 centrifugal fan coil unit MAINTENANCE MANUAL To perform all the steps shown, wear the individual protective devices: protective glasses, masks and anti-cut gloves. It is advisable to have the cleaning operations carried out by suitably trained personnel.
- Page 11 INSTALLATION, USE, Vers. 2018-0 centrifugal fan coil unit MAINTENANCE MANUAL Pic. 23 REMOVE THE HEAT EXCHANGER (STEP #3) CAUTION To remove the exchanger, disconnect the unit from the hydraulic line. To facilitate this operation, the installation of shut-off valves is always recommended.
-
Page 12: Dismantling The Appliance
INSTALLATION, USE, Vers. 2018-0 centrifugal fan coil unit MAINTENANCE MANUAL PEST CONTROL PHASE DISMANTLING THE APPLIANCE For the total disinfection of the unit, remove the motor complete with plate as This appliance is made to last for many years. Qualified personnel are needed described in “STEP #1”. - Page 13 NOTE...
- Page 14 NOTE...
- Page 16 With the perspective of improvement, and against the continuous action of research and development, the Manufacturer might modify, even without any prior notice, the given technical data.
Need help?
Do you have a question about the Air Hygienic Series and is the answer not in the manual?
Questions and answers