Apco HealthView HPSTube-FS Assembly Instructions

HPSTube-FS Free Standing Stanchion
Unpack carton and check contents listed on this page before assembly. The soap dispenser is packaged separately, assemble the stand first and
attach the tube before installing the soap dispenser in the Tube. Follow the steps below to assemble the Tube.
Step One: Attach steel Base Plate (A) to Lower Post (C). Locate bolt
(B) to join base to post, place a drop of Thread Locker (G) on bolt before
threading into post. Use hex wrench (H) provided to secure bolt.
Step Two: Remove white protective cap from threaded stud on lower
post and apply a drop of thread locker to stud. Attach Upper Post (E) by
threading tube on stud on Lower Post (C).
Step Three: Remove white protective cap from threaded stud on Upper
Post (E) and apply a drop of thread locker to stud. Attach Tube (F) by
threading on to stud. Note: Be sure to turn Tube until the post enters
tube bottom cavity completely and contacts the black friction pad.
Stanchion assembly is complete.
Installing Soap Dispenser: Remove top cap from Tube, remove green
tape. Place soap dispenser on foam lifters inside Tube.
Replace Tube Cap by depressing the Snap Buttons and placing cap flange
inside the tube, once cap is seated, turn cap until snap buttons engage.
Removing Cap: Compress one snap button while at the same time,
lift soap dispenser upward. Use thumb finger nail to press button completely
in. Cap removal may require practice as the snap button is designed to
be tamper proof.
Cap Replacement: Re-locking the lid is easily done by compressing
snap buttons and inserting lid and turning until buttons snap in place.
Push & Lift
Patent Pending
APCO
388 Grant Street, SE, Atlanta, Georgia USA 30312-2227
F. Tube
Apply thread locker here
E. Upper Post
D. Splice Connector
Apply thread locker here
C. Lower Post
A. Base Plate
B. Bolt
Apply thread locker here
Description
QTY/Assy
(1)
A. Base Plate
(1)
B. Bolt
(1)
C. Lower Post
(1)
D. Splice Connector
(1)
E. Upper Post
F. Tube (1)
(1)
G. Thread locker
(1)
H. Hex Wrench
Telephone (404) 688-9000
10/13/2011
Assembly
Instructions
HPSTube Assembly
Complete
B.
1/4-20 x 1" Pan HD Socket - SS
Machine Screw
H.
5/32" Hex Wrench
G.
.5 ml medium strength
thread locker
Web: www.apcosigns.com IS353