Page 1
Pro Fitness Weight Rack Assembly & User Instructions - 461/7736 Please keep for future reference Important – Please read these instructions fully before assembly or use These instructions contain important information which will help you get the best from your equipment and ensure safe and correct assembly, use and maintenance.
Contents Safety Information Components - Parts Components – Fixings Assembly Instructions Product information Care and Maintenance Exploded Parts Diagram Parts List Guarantee...
Safety Information Important – Please read fully before assembly or use To reduce the risk of serious injury, read the entire manual before you assemble or operate the Pro Fitness Weight Rack. In particular, note the following safety precautions. Assembly •...
MUST read all instructions before using any fitness equipment. Argos assumes no responsibility for Components - Parts If you have damaged or missing parts, please personal injury or property damage sustained by or through the use of this product. call the Customer Helpline: 0345 640 2020. Please check you have all parts listed below Note: Some of the smaller components may be pre-fitted to larger components.
Components - Fixings Please check you have all fittings listed below Note: Some of the smaller components may be pre-fitted to the larger components. Please check carefully before contacting Argos regarding any missing components. Please prepare an adjustable spanner by yourself when you are intend to assemble this machine.
Assembly instructions Step 1 Attach the Weight Plate Posts (5) to the Cross Beam (3) using 3 x M10×20mm Allen Bolts (12) and 3 x Ø10mm Washers (13).
Page 7
Assembly instructions Step 2 Connect the both ends of the Cross Beam (3) to the Left & Right Upright Frame (1, 2) using 4 x M10×70mm Carriage Bolts (10), 4 x Ø10mm Washers (13), 4 x M10 Aircraft Nuts (14) and 2 x 120×45×90×2mm Brackets (6).
Page 8
Assembly instructions Step 3 Connect the both ends of the Dumbbell Rack (4) to the Left & Right Upright Frame (1, 2) using 4 x M10×55mm Carriage Bolts (11), 4 x Ø10mm Washers (13), 4 x M10 Aircraft Nuts (14). Attach 3 x φ46×φ26×18 Rubber Bumper (15) to 3 x Weight Plate Post (5) respectively.
Product information Care and Maintenance Max. 100Kgs Max. 20Kgs Max. 20Kgs Max. 50Kgs 280mm 415mm 1. Max capacity on the Dumbell Rack (4) is 100Kgs. 2. The gap between the two Dumbell Rack (4) is 107-117mm. 3. Max capacity on each of the Barbell bar support is 20Kgs. 4.
Care and Maintenance Care and Maintenance components immediately and or if you think that you may The safety level of the and/or keep the equipment out have parts missing, contact equipment can only be of use until repair. the Customer Helpline: maintained if it is examined 0345 640 2020.
Exploded Parts List Part Description Qty. Part Description Qty. Left Upright Frame φ25×1.5 End Cap Right Upright Frame M10×70mm Carriage Bolt Cross Beam M10×55mm Carriage Bolt Dumbbell Rack M10×20mm Allen Bolt Weight Plate Post φ10 Washer Bracket M10 Aircraft Nut □38×1.5 End Cap φ46×φ26×18 Rubber Bumper □50×1.5 End Cap...
Guarantee Product Guarantee This product is guaranteed against manufacturing defects from a period of Year This product is guaranteed for twelve months from the date of original purchase. Any defect that arises due to faulty materials or workmanship will either be replaced, refunded or repaired free of charge where possible during this period by the dealer from whom you purchased the unit.