Summary of Contents for NASA Marine SUPERNOVA
- Page 1 DESIGNED AND MANUFACTURED IN ENGLAND SUPER NOVA MARINE INSTRUMENTS NASA MARINE Ltd. BOULTON ROAD RoHS 2002/95/EC STEVENAGE HERTS SG1 4QG ENGLAND (01438) 354033...
-
Page 3: Fitting Instructions
Bend the bracket to the required angle. Drill the bracket and fix to the mast using self tapping screws. Make final adjustments to the bracket to ensure the flange is vertical then bolt the SUPERNOVA to the flange using the mounting blocks and stainless steel fasteners provided. -
Page 4: Mounting Options
* Paint any scratches on the mounting bracket which result from drilling or bending. * Do not fit to vessels over 12 metres. * Do not try to bend the bracket using the SUPERNOVA as a lever. * Ensure all electrical connections are properly made and are waterproof. - Page 5 CONNECTING THE SUPERNOVA ANCHOR OR TRI-COLOUR. Connect the power cable to the 12 volt supply (Red positive and Black negative) through a 1 Amp fuse and a suitable switch. (Fig 5) Fig. 5 1 Amp Fuse 12 volt Switch Supply BLACK CONNECTING THE COMBI LIGHT.
- Page 6 Supply A typical switch wiring IMPORTANT. Supernova navigation lights are intended for use on vessels up to 12 metres in length. They comply with CE generic EMC standards and are waterproof to IP65 and IP67. There is no specific EU standard for LED navigation...
-
Page 8: Limited Warranty
Prior to unpacking this instrument read and fully understand the installation instructions. Only proceed with the installation if you are competent to do so. Nasa Marine Ltd. will not accept any responsibility for injury or damage caused by, during or as a result of the installation of this product.