Page 1
General-Purpose Thermal Printer Silent Series Model 160 Installation and User Guide...
Page 2
Revision 1.2.1 Centrodyne Inc., All rights reserved. The information in this document is the property of Centrodyne Inc. Reproduction or transcription by any means, in whole or in part, without the prior written consent of Centrodyne Inc., is prohibited.
Warranty................................. 4 Installation ..............................4 Package Contents............................4 Finding a Suitable Installation Surface....................... 4 Installing with a Centrodyne S600 Taximeter .................... 6 Installing with a Data Terminal ........................6 Using the Model 160 Printer .......................... 8 Controls and Indicators..........................8 Loading the Paper............................
Centrodyne as not related to the manufacturing process. The customer is responsible for the cost of shipping the product back to Centrodyne’s service center for warranty service. The item will be returned at Centrodyne’s expense.
Revision 1.2.1 Installing with a Centrodyne S600 Taximeter When installing the Model 160 with a Centrodyne S600 taximeter there is no need to separately wire power and ground into the unit. These are provided through the cable connecting the Model 160 and the taximeter.
Page 7
NOTE: The red power wire should be wired to the 12V source through a 5 Amp fuse. (NOT supplied by Centrodyne) You may be able to locate one in the vehicle fuse box; otherwise an inline fuse may be used.
160 User Guide Revision 1.2.1 Using the Model 160 Printer Controls and Indicators The model 160 printer has 2 LEDs at the front of the unit, next to the RJ-45 connector. The red LED indicates that the printer is powered. The green LED lights when the printer is printing.
160 User Guide Revision 1.2.1 Loading the Paper NOTE : The 160 printer accommodates paper rolls with the following maximum dimensions: Thickness: 0.08 mm Width: 58 mm (approx 2 ¼”) Diameter: 48 mm (75-85 feet long) Using larger/thicker paper roles may damage the printer. ...
160 User Guide Revision 1.2.1 Push back here Figure 8 NOTE: The 160 printer door must remain closed when printing. Printing with the door open may result in poor results and/or damage to the print-head. Printing The printer door should be securely closed whenever the unit is printing. ...
160 User Guide Revision 1.2.1 Printing Configuration Data You can have the 160 print out its configuration data using the following procedure: Make sure that the printer is powered off. (RJ-45 removed) Press and hold the paper-feed button. ...
NOTE: You do not need to push down on the release lever. Closing the printer door automatically pushes the release lever into the proper position. Contact Centrodyne For technical support or service you may email or call us at: support@centrodyne.com...